This thesis presents an analytical approach using Root-Loci method for designing optimum passive series RC snubbers for continuous-current synchronous buck switch mode power supply (SMPS).
Synchronous buck SMPS is the most popular power converter topology found in modern consumer electronics. It offers relatively good efficiency to target the high-current and low-voltage requirements while it is also relatively inexpensive to implement.
Passive series RC snubbers are simple, efficient and cost-effective open-loop equalizer circuit for synchronous buck SMPS. Its purpose is to control and to balance between the rate of rise and the overshoots of transient switching waveform in order to optimize efficiency and reliability
Existing methods of RC snubber design are solely based on second-order approximation. It is investigated in this research that this approximation is highly inaccurate in SMPS applications because higher order equivalent models are required for the load path of the SMPS. The results using the RC snubbers obtained from existing method are shown to be unsatisfactory without correlation to the calculations and simulations based on second-order approximation. Optimum RC values obtained using Root-Loci approach presented in this thesis are shown to correlate to both Spice simulation and lab measurements.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OWTU.10012/963 |
| Date | January 2005 |
| Creators | Chen, Yen-Ming |
| Publisher | University of Waterloo |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | Thesis or Dissertation |
| Rights | Copyright: 2005, Chen, Yen-Ming . All rights reserved. |
Page generated in 0.0021 seconds