This study empirically compares the Classical Test Theory (CTT) and the Partial Credit Model
(PCM) of Rasch focusing on the invariance of item parameters. The invariance concept which is
the consequence of the principle of specific objectivity was tested in both CTT and PCM using the
results of learners who wrote the National Senior Certificate (NSC) Mathematics examinations in
2010. The difficulty levels of the test items were estimated from the independent samples of learn-
ers. The same sample of learners used in the calibration of the difficulty levels of the test items in
the PCM model were also used in the calibration of the difficulty levels of the test items in CTT
model. The estimates of the difficulty levels of the test items were done using RUMM2030 in the
case of PCM while SAS was used in the case of CTT. RUMM2030 and SAS are both the statistical
softwares. The analysis of variance (ANOVA) was used to compare the four different design groups
of test takers. In cases where the ANOVA showed a significant difference between the means of the
design groups, the Tukeys groupings was used to establish where the difference came from.
The research findings were that the test items' difficulty parameter estimates based on the CTT theoretical framework were not invariant across the different independent sample groups. The over-
all findings from this study were that the CTT theoretical framework was unable to produce item
difficulty invariant parameter estimates. The PCM estimates were very stable in the sense that for
most of the items, there was no significant difference between the means of at least three design
groups and the one that deviated from the rest did not deviate that much. The item parameters of
the group that was representative of the population (proportional allocation) and the one where the
same number of learners (50 learners) was taken from different performance categories did not differ
significantly for all the items except for item 6.6 in examination question paper 2. It is apparent
that for the test item parameters to be invariant of the group of test takers in PCM, the group of
test takers must be heterogeneous and each performance category needed to be big enough for the proper calibration of item parameters.
The higher values of the estimated item parameters in CTT were consistently found in the sample
that was dominated by the high proficient learners in Mathematics ("bad") and the lowest values
were consistently calculated in the design group that was dominated by the less proficient learners. This phenomenon was not apparent in the Rasch model. / Mathematical Sciences / M.Sc. (Statistics)
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:unisa/oai:uir.unisa.ac.za:10500/18362 |
| Date | 05 1900 |
| Creators | Mokilane, Paul Moloantoa |
| Contributors | Olaomi, John |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Dissertation |
| Format | 1 online resource ([viii], 110 leaves) |
Page generated in 0.0023 seconds