In order to preserve groundwater as a viable source of drinking water, remedial measures must be
applied where appropriate. The application of the various remedial technologies is site and
contaminant dependent. Differing geology, subsurface soil, groundwater geochemistry, type of
contaminant present, cost and even accessibility to the site are all considerations when selecting an
appropriate remedial system. At many sites oxygen is a limiting factor for aerobic degradation of
many organic compounds like methyl tert butyl ether (MTBE) and hydrocarbons found in diesel
and fuel oil, etc. (Nyer et al, 2002).
Mechanisms limiting the success of getting the oxygen out of the passive release well include:
· Slow chemical diffusion of oxygen in water;
· Limited cross section of the groundwater flowing into the well and advecting oxygenated
water back into the aquifer; and
· Generally weak transverse dispersion, both horizontal and vertical, during subsequent
advection of the oxygenated water in the porous media.
These issues must be recognized even in the design of a passive release well remediation system.
For example, a typical remedial objective is to deliver dissolved oxygen across the width and
vertical extent of a contaminant zone in an aquifer. The width of the oxygen plume around the
injection well defines how many oxygen-release wells are required to create a curtain of oxygen.
Cost-effective design dictates fewer wells, while effective coverage may dictate more wells placed
closer together. Thus, understanding the transverse width over which significant oxygen is
passively released to the aquifer (the “radius of influence”) is a critical design parameter and the
focus of this thesis. Due to the difficulty in getting a passively released dissolved oxygen plume to
transversely encompass the total width of a contaminant plume, other more efficient means of
introducing oxygen into the subsurface are required. Injecting amended water directly into a
release well would increase the transverse distance in which dissolved oxygen would spread.
A series of experiments were conducted at CFB Borden to assess the efficacy of an oxygen releasing
technology called the iSOC™. The experiments were all conducted in the same manner, by
connecting a tank of oxygen to the iSOC™ unit, which then was placed in a release well and allowed
to run in experiment 1 for 103 days, experiment 2 for 132 days and experiment 3 for 29 days.
iv
Dissolved oxygen concentrations were measured at varying time intervals throughout each
experiment using an Orion dissolved oxygen probe. Results of each of the three experiments were
very similar in that dissolved oxygen was only detected in a very narrow plume (10 cm to 25 cm in
width) within 1 m of the release well.
The presence of BTEX, BOD and COD within the groundwater and soil at the site were investigated
to assess if presented a significant enough sink for the oxygen and thereby limiting the transverse
growth of the dissolved oxygen plume. Groundwater results indicated that while dissolved oxygen
was utilized for BTEX degradation and to overcome the natural oxygen demand (both BOD and
COD) at the site, the amount of oxygen released into the aquifer would have satisfied both of these
processes. The COD of the soil at the site presented a higher oxygen demand than the groundwater
and presented a greater limiting factor to the transverse growth of the oxygen plume.
By releasing oxygen passively with the iSOC™ only a small transverse portion of the Borden aquifer
was likely influenced. This limitation has been noted in general for passive release technologies
(Wilson & Mackay, 1995). While the iSOCÔ technology develops very high oxygen levels in the
groundwater in the release well, it does not overcome the hydrogeological constraint of limited
transverse dispersion. Thus, a high oxygen concentration is delivered to a very narrow segment of
the aquifer.
Overall, transverse dispersion has a minimal impact on a passively release oxygen plume,
particularly in close proximity to the release well, but once the plume has migrated a distance away
from the release well the effect of transverse dispersion increases. The oxygen demand of an
aquifer can also limit the effect of transverse and longitudinal dispersion. If a site has a high
chemical or biological oxygen demand the released gas will be consumed before dispersion can
have an effect on the plume. By injecting nutrient rich water into a release well the water will
forcibly overcome any influence transverse dispersion will have in and around a release well,
thereby relying on longitudinal dispersion to create a larger area for contaminant degradation to
occur.
Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OWTU.10012/4665 |
Date | 28 July 2009 |
Creators | Naas, Claudia |
Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
Language | English |
Detected Language | English |
Type | Thesis or Dissertation |
Page generated in 0.0024 seconds