Azimuthal resistivity was performed at the King site, near Birsay, Saskatchewan to characterize the orientation and extent of fracturing in a glacial till. The target consisted of shallow (less than 4m deep) fractures in the upper oxidized portion of the Battleford Formation.<p> The fractures were visible in soil cores, but their orientation and extent were not known at the time of investigation. It was hoped that if the azimuthal resistivity method could be successfully applied at this site it could be
used as an in situ fracture mapping tool at other sites. <p> Preliminary azimuthal resistivity surveys failed to detect a consistent
anisotropic pattern that could be attributed to fracturing. A refined method of azimuthal resistivity was developed that built a 3D resistivity model of the site assuming a heterogeneous, isotropic earth. This model was used to predict and remove the effect of heterogeneity on the azimuthal resitivity
observations. The results from the refined method also failed to detect a consistent anisotropic pattern. <p>Any single azimuthal resistivity observation from either the preliminary or refined surveys would have provided data that could have been interpreted as
anisotropy due to fractures. It was only by comparing many azimuthal observations across the site that the lack of consistent azimuthal pattern became apparent. <p>It is recomended that an analysis of several observations be made before any interpretation of anisotropy is made for azimuthal resistivity sureveys in general.
Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:SSU.etd-02232006-152036 |
Date | 06 March 2006 |
Creators | Boris, Mark |
Contributors | Schreiner, Bryan, Merriam, James B., Hendry, M. Jim, Hajnal, Zoltan, Ansdell, Kevin M. |
Publisher | University of Saskatchewan |
Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
Language | English |
Detected Language | English |
Type | text |
Format | application/pdf |
Source | http://library.usask.ca/theses/available/etd-02232006-152036/ |
Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0015 seconds