The work focuses on new processes for the preparation of lactic acid derivatives. The main objective was to verify the feasibility of preparing high molecular weight polylactide using ethyl lactate as a precursor of lactide synthesis. Part of the work is devoted to the new ethyl lactate synthesis method. The experimental part of the thesis is divided into partial key steps on the way from the lactic acid to the high molecular polylactide. The preparation of anhydrous ethyl ester of lactic acid (EtLA) was solved in an innovative way using alcoholysis of the oligomeric lactic acid. A kinetic model for isothermal alcoholysis and equimolar reactants ratio was derived from this method. The ethyl lactate was oligomerized by transesterification into the low and high molecular weight oligomer with the help of newly found catalysts suitable for the reaction medium. Stannous lactate was used as catalyst for oligomerization of the low molecular weight polymer suitable for the preparation of lactide (Mn 1000 g.mol-1). Experimental polymerization of ethyl lactate into high molecular weight product in tens of kDa has been investigated with newly synthesized tetraethyllactoyl titanate, Ti(EtLA)4. The laboratory method was derived for the depolymerization of the oligomer into lactide. Optimal conditions found for lactidation are as follow: temperature 225 ° C, pressure 2 kPa, catalysis 0,05 mol% of stannous lactate (with respect to oligomer lactate units). The prepared lactide was refined to polymer grade purity by distillation and subsequent recrystallization from ethyl acetate and toluene. The method for the preparation of high molecular weight PLA through ROP polymerization of lactide has been optimized. By optimization, suitable catalyst concentration was found in combination with the polymerization temperature and the polymerization length. An equimolar mixture of Tin 2-ethylhexanoate and 1-decanol was used as the catalytic system. The optimal ROP conditions for achieving the maximum molecular weight and suppressed polymer coloration (yellowing) are: catalyst concentration 0,01 mol%, temperature 160 °C, and polymerization length 4 hours. PLA with molecular weight Mw= 447 ± 7,8 kg.mol-1 was prepared at these conditions and good repeatability of the result was achieved. The effect of naturally occurring lactide contaminants and their influence on the course and ROP result was experimentally verified on the optimized polymerization system. The purpose was to explore the effect of lactide contamination with water and ethanol as natural lactide contaminants. The results clearly confirm the orderly lower sensitivity of the polymerization system for the presence of ethanol as compared to water contamination. In the case of the presence of water, the course and the result of the polymerization in terms of both the conversion and achieved molecular weights are negatively affected, even when the water content is in the order of 0,001%. Conversely, the presence of ethanol has a positive effect on lactide conversion and polymer polydispersity. Lactides with an alcohol content of about one-tenth of a percent are suitable to reach molecular weights of PLA similar to commercially available products. This difference shoves a significant advantage in the proposed technology of preparing PLA from ethyl lactate, especially for easier purification of crude lactide into polymer grade purity.
| Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:386764 |
| Date | January 2018 |
| Creators | Figalla, Silvestr |
| Contributors | Svěrák, Tomáš, Herink,, Tomáš, Petrůj, Jaroslav |
| Publisher | Vysoké učení technické v Brně. Fakulta chemická |
| Source Sets | Czech ETDs |
| Language | Czech |
| Detected Language | English |
| Type | info:eu-repo/semantics/doctoralThesis |
| Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.0016 seconds