Indiana University-Purdue University Indianapolis (IUPUI) / Statement of problem: Yttria-partially stabilized tetragonal zirconia polycrystal (Y-TZP) all-ceramic restorations have been reported to suffer from chipping or cracking of the veneering porcelain (VP) as the most common complication. There is little information in the literature regarding the influence of surface treatment on VP shear bond strength to Y-TZP after cyclic loading. Purpose of this study: The goals of this study were (1) to investigate the influence of zirconia surface treatments on veneering porcelain shear bond strength and (2) to investigate the influence of cyclic loading on the shear bond strength between VP and Y-TZP. Materials and Methods: 48 cylinder–shaped specimens (6mm in diameter and 4mm in height) were divided into 4 groups containing 12 specimens each according to the surface treatment. As a control group (C), no further treatment was applied to the specimens after grinding. Group H was heat-treated as a pretreatment according to the manufacturer’s recommendations. Group S was airborne-particle abraded with 50 µm alumina (Al2O3) particles under a pressure of 0.4 MPa for 10 seconds. In the group SH, the heat-treatment was performed after the airborne-particle abrasion. A VP cylinder (2.4 mm in diameter and 2 mm in height) was applied and fired on the prepared Y-TZP specimens. The shear bond strength was tested using a universal testing machine. Six specimens from each group were subjected to fatigue (10,000cycles, 1.5Hz, 10N load) before testing. Results: The 3-way ANOVA showed no statistically significant effect of surface treatment and cyclic loading on shear bond strength. The highest mean shear bond strength was recorded for the air-particle abrasion group without cyclic loading (34.1 + 10 MPa). The lowest mean shear bond strength was the air-particle abrasion group with cyclic loading (10.7 ± 15.4 MPa). Sidak multiple comparisons procedure demonstrated cyclic loading specimens had significantly lower shear bond strength than non-cyclic loading specimens after air-particle abrasion without heat treatment (p=0.0126) Conclusion: Within the limitations of this study, (1) Shear bond strength between Y-TZP and VP is not affected statistically by surface treatment using heat treatment, airborne-particle abrasion, and heat treatment after airborne-particle abrasion. (2) There is significant difference in shear bond strength with air-particle abrasion between with and without cyclic loading groups. This difference suggested that air-particle abrasion should be avoided in clinical situations as a surface treatment without heat treatment.
| Identifer | oai:union.ndltd.org:IUPUI/oai:scholarworks.iupui.edu:1805/3724 |
| Date | January 2013 |
| Creators | Nishigori, Atsushi |
| Contributors | Platt, Jeffrey A., 1958-, Brown, David T., Ando, Masatoshi, Bottino, Marco C., Levon, John A. |
| Source Sets | Indiana University-Purdue University Indianapolis |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0021 seconds