The objective of this project was to design and implement an experimental hydraulic system that simulates joint flexibility of a single rigid link flexible joint robot manipulator, with the ability of changing the joint flexibilitys parameters. Such a system could facilitate future control studies of robot manipulators by reducing investigation time and implementation cost of research. It could also be used to test the performance of different strategies to control the movement of flexible joint manipulators.<p>A hydraulic rotary servo motor was used to simulate the action of a flexible joint robot manipulator. It was a challenging task, since the control of angular acceleration was required. <p>A single-rigid-link, elastic-joint robot manipulator was mathematically modeled and implemented using Matlab. Joint flexibility parameters such as stiffness and damping, could be easily changed. This simulation was considered as a function generator to drive the hydraulic flexible joint robot. In this study the desired angular acceleration of the manipulator was used as the input to the hydraulic rotary motor and the objective was to make the hydraulic system follow the desired acceleration in the frequency range specified. The hydraulic system consisted of a servovalve and rotary motor. <p>A hydraulic actuator robot was built and tested. The results indicated that if the input signal had a frequency in the range of 5 to 15 Hz and damping ratio of 0.1, the experimental setup was able to reproduce the input signal with acceptable accuracy. Because of the inherent noise associated with the measurement of acceleration and some severe non-linearities in the rotary motor, control of the experimental test system using classical methods was not as successful as had been anticipated. This was a first stage in a series of studies and the results provide insight for the future application of more sophisticated control schemes.<p>
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:SSU.etd-06282007-130256 |
| Date | 28 June 2007 |
| Creators | Dezfulian, Shahram |
| Contributors | Gokaraju, Ramakrishna, Fotouhi, Reza, Dolovich, Allan T., Burton, Richard T., Schoenau, Greg J. |
| Publisher | University of Saskatchewan |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://library.usask.ca/theses/available/etd-06282007-130256/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0022 seconds