Fan system efficiency for modern aircraft engine design is increasing to the point that bypass duct geometry is becoming a significant contributor and could ultimately become a limiting factor. To investigate this, a number of methods are available to provide qualitative and quantitative analysis of the flow around the loss mechanisms present in the duct. Particle image velocimetry (PIV) is a strong candidate among experimental techniques to address this challenge. Its use has been documented in many other locations within the engine and it can provide high spatial resolution data over large fields of view. In this work it is shown that these characteristics allow the PIV user to reduce the spatial sampling error associated with sparsely spaced point measurements in a large measurement region with high order gradients and small spatial scale flow phenomena. A synthetic flow featuring such attributes was generated by computational fluid dynamics (CFD) and was sampled by a virtual PIV system and a virtual generic point measurement system. The PIV sampling technique estimated the average integrated velocity field about five times more accurately than the point measurement sampling due to the large errors that existed between each point measurement location. Despite its advantages, implementation of PIV can be a significant challenge, especially for internal measurement where optical access is limited. To reduce the time and cost associated with iterating through experiment designs, a software package was developed which incorporates basic optics principles and fundamental PIV relationships, and calculates experimental output parameters of interest such as camera field of view and the amount of scattered light which reaches the camera sensor. The program can be used to judge the likelihood of success of a proposed PIV experiment design by comparing the output parameters with those calculated from benchmark experiments. The primary experiment in this work focused on the Pratt and Whitney Canada JT15D-1 aft support strut wake structure in the bypass duct and was comprised of three parts: a simulated engine environment was created to provide a proof
of concept of the PIV experiment design; the PIV experiment was repeated in the full scale engine at four fan speeds ranging from engine idle up to 80% of the maximum corrected fan speed; and, finally, a CFD simulation was performed with simplifying assumptions to provide insight and perspective into the formation of the wake structures observed in the PIV data. Both computational and experimental results illustrate a non-uniform wake structure downstream of the support strut and support the hypothesis that the junction of the strut and the engine core wall is creating a separate wake structure from that created by the strut main body. The PIV data also shows that the wake structure moves in the circumferential direction at higher fan speeds, possibly due to bulk swirl present in the engine or a pressure differential created by the support strut. The experiment highlights the
advantages of using PIV, but also illustrates a number of the implementation challenges present, most notably, those associated with consistently providing a sufficient number of seeding particles in the measurement region. Also, the experiment is the first to the author's knowledge to document the use of PIV in a full scale turbofan engine bypass duct. / Master of Science
| Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/78327 |
| Date | 10 July 2017 |
| Creators | George, William Mallory |
| Contributors | Aerospace and Ocean Engineering, Lowe, K. Todd, O'Brien, Walter F., Schetz, Joseph A. |
| Publisher | Virginia Tech |
| Source Sets | Virginia Tech Theses and Dissertation |
| Detected Language | English |
| Type | Thesis |
| Format | ETD, application/pdf |
| Rights | This item is protected by copyright and/or related rights. Some uses of this item may be deemed fair and permitted by law even without permission from the rights holder(s), or the rights holder(s) may have licensed the work for use under certain conditions. For other uses you need to obtain permission from the rights holder(s). |
Page generated in 0.0034 seconds