The thesis describes the knowledge from a round tube bending technology, as a description of conventional and unconventional devices. There are technological parameters in relation to the creation of defects, and equations for determining the bending moment. These knowledge has been generalized and applied to solution the changes of cross-section shape and thickness in the bending of square cross-section. The solution was implemented to specific component (20x2 mm steel tube with two successive radii R57,2 and R131,5). The results of experiments shows that the material is almost rigid-perfectly plastic, in the most stressed areas has a sufficient supply of material formability. Thickness measurement was applied to calculate the approximate center of gravity changes. This shows a shift of 1.4 mm, which is negligible value for the pure bending. The end of the thesis summarizes the deficiencies of current manufacturing technology, which used mandrel is inadequate, wrong located and poor lubrication.
Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:229928 |
Date | January 2011 |
Creators | Fišar, Luboš |
Contributors | Peterková, Eva, Samek, Radko |
Publisher | Vysoké učení technické v Brně. Fakulta strojního inženýrství |
Source Sets | Czech ETDs |
Language | Czech |
Detected Language | English |
Type | info:eu-repo/semantics/masterThesis |
Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.0018 seconds