The safety and functionality of engineering systems can be affected adversely by faults or wear in system components. Therefore, methods for detecting such faults/wear and ameliorating their effects to avoid system failure are important. Designing schemes for the detection and diagnosis of faults is becoming increasingly important in engineering due to the complexity of modern industrial systems and growing demands for quality, cost efficiency, reliability, and the safety issue. In safety/mission critical applications, fault detection can be combined with accommodation/reconfiguration (after a fault) to achieve fault tolerance allowing the system to complete or abort its function in a way that is sub-optimal but does achieve the design objective. This thesis discusses research carried-out on the development and validation of a model-based fault detection and isolation (FDI) system for a pneumatically actuated Stewart platform. The Stewart-Gough platform provides six degrees of freedom consisting of three translational and three rotational degrees of freedom (x, y, z, pitch, roll, & yaw). As these platforms can be fast acting (rapid motion) and can handle reasonable loads, they can become dangerous, especially when fault(s) in the platform mechanism, drivetrain or control system occur. Therefore, as a safety critical application it is imperative that fault tolerant schemes are applied in order to provide a safe working environment. The design concept of the FDI scheme for the full Stewart-Gough platform is first designed using a single cylinder set-up. This modular concept is adopted so that a robust fault tolerant control scheme can be designed basically off-line (i.e. not attached to the Stewart Gough platform). This approach is adopted as requirements are easier to understand using a single cylinder set-up. The modular design approach subdivides the whole system into smaller sections (modules) that can be independently created and then used in the complete Stewart-Gough platform. The main contributions of the work are that a pneumatically actuated Stewart-Gough platform has been designed, built, and commissioned. A mathematical model has been developed and has been validated against experimental results. Two control approaches have been designed and compared. A fundamental comparative study of parity equations and Kalman filter observer banks for fault detection in pneumatic actuators has been conducted. The parity equations and Kalman filter approaches have been extended to provide a combined fault detection scheme. The FDI and control schemes have been combined in a modular Fault Tolerant Control (FTC) scheme for a pneumatic cylinder. The resulting FTC scheme has been validated by experimentation and demonstrated on the single cylinder test rig. The FTC scheme has been extended to all 6 cylinders (and including fault management at top level) of Stewart-Gough platform. The FTC scheme has been validated by experimentation and demonstrated on the Stewart-Gough platform test rig.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:519969 |
| Date | January 2010 |
| Creators | Grewal, Karmjit Singh |
| Publisher | Loughborough University |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | https://dspace.lboro.ac.uk/2134/6243 |
Page generated in 0.002 seconds