This study focuses on the development of a stochastic simulation methodology to study the effects of cure kinetics uncertainty, in plane fibre misalignment and boundary conditions uncertainty on the cure process of composite materials. Differential Scanning Calorimetry was used to characterise cure kinetics variability of a commercial epoxy resin used in aerospace applications. It was found that cure kinetics uncertainty is associated with variations in the initial degree of cure, activation energy and reaction order. Image analysis was employed to characterise in plane fibre misalignment in a carbon fibre ±45º non-crimp fabric. The experimental results showed that variability in tow orientation was significant with a standard deviation of about 1.2º. A set of experiments using an infusion set-up was carried out to quantify boundary conditions uncertainty related to tool temperature, ambient temperature and surface heat transfer coefficient using thermocouples (tool/ambient temperature) and heat flux sensors (surface heat transfer coefficient). It was concluded that boundary conditions uncertainty can show considerable short term and long term variability. Conventional Monte Carlo and Probabilistic Collocation Method were integrated with a thermo-mechanical cure simulation model in order to investigate the effect of cure kinetics, fibre misalignment and boundary conditions variability on process outcome. The cure model was developed and implemented using a finite element model incorporating appropriate material sub-models of cure kinetics, specific heat capacity, thermal conductivity, moduli, thermal expansion and cure shrinkage. The effect of cure kinetics uncertainty on the temperature overshoot of a thick carbon fibre epoxy flat panel was investigated using the two stochastic simulation schemes. The stochastic simulation results showed that variability in cure kinetics can introduce a significant scatter in temperature overshoot, presenting a coefficient of variation of about 30%. Furthermore, it was shown that the collocation method can offer an efficient solution with significantly lower computational cost compared to Monte Carlo at comparable accuracy. Stochastic simulation of the cure of an angle shaped carbon fibre-epoxy component within the Monte Carlo scheme showed that fibre misalignment can cause considerable variability in the process outcome. The coefficient of variation of maximum residual stress can reach up to approximately 2% (standard deviation of 1 MPa) whilst qualitative and quantitative variations in final distortion of the cured part occur with the standard deviation in twist and corner angle reaching values of 0.4 º and 0.05º respectively. Simulation of the cure of a thin carbon fibre-epoxy panel within the Monte Carlo scheme indicated that surface heat transfer and tool temperature variability dominate variability in cure time, resulting in a coefficient of variation of about 22%. In addition to Monte Carlo, the effect of surface heat transfer coefficient and tool temperature variations on cure time was addressed using the collocation method. It was found that probabilistic collocation is capable of capturing variability propagation with good accuracy while offering tremendous benefits in terms of computational costs.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:650159 |
| Date | January 2015 |
| Creators | Mesogitis, Tassos |
| Contributors | Skordos, Alexandros A.; Long, Andrew |
| Publisher | Cranfield University |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://dspace.lib.cranfield.ac.uk/handle/1826/9216 |
Page generated in 0.0022 seconds