Return to search

Evaluation of the torsion test for determining the shear strength of structural lumber

The torsion test was evaluated as a method for determining the shear
strength of full-size structural lumber. The evaluation involved an experimental
length study, an experimental depth study, and a finite element study.
The length study consisted of fifty nominal 2x4 specimens, ten specimens
for each length, and ten American Society for Testing and Materials (ASTM)
shear blocks. One 14 foot long board yielded one specimen for each length: (a)
21.0", (b) 28.5", (c) 32.0", (d) 35.5", (e) 39.0", and (f) an ASTM D143-94 shear
block. The statistical analysis revealed no evidence that the length affected the
shear strength.
The depth study consisted of fifty specimens, ten specimens for each
depth: (a) 2x4, (b) 2x6, (c) 2x8, (d) 2x10, and (e) 2x12. In addition, fifty ASTM
shear blocks, one block for each specimen, were tested. The statistical study did not reveal convincing evidence of a depth effect on shear strength, even
after accounting for specific gravity and shear span as covariates.
Failure modes for the torsion samples involved a longitudinal shear crack
at the mid-point of the longest side, which propagated toward the ends of the
specimen and through the cross section perpendicular to the growth rings.
The finite element model revealed that uniform shear stress occurs within
the shear span, which begins and ends a distance of approximately two times
the depth plus the grip distance away from each end of the member. In addition,
torsion theory verified that the experimental shear failure plane that occurs
within the shear span is parallel to the grain and the shear slippage is also
parallel to the grain, similar to the known shear failure in specimens subjected to
bending loads.
Based on the results of this study, the torsion test is the best practical
method to determine the pure shear strength of full-size structural lumber,
because the test yields 100% shear failures and the specimen is in a state of
pure shear stress. / Graduation date: 1998

Identiferoai:union.ndltd.org:ORGSU/oai:ir.library.oregonstate.edu:1957/33992
Date06 November 1997
CreatorsHeck, Leanne Renee
ContributorsMiller, Thomas H., Gupta, Rakesh
Source SetsOregon State University
Languageen_US
Detected LanguageEnglish
TypeThesis/Dissertation

Page generated in 0.0017 seconds