Return to search

Time-lapse seismic monitoring of subsurface fluid flow

Time-lapse seismic monitoring repeats 3D seismic imaging over a reservoir to map fluid movements in a reservoir. During hydrocarbon production, the fluid saturation, pressure, and temperature of a reservoir change, thereby altering the acoustic properties of the reservoir. Time-lapse seismic analysis can illuminate these dynamic
changes of reservoir properties, and therefore has strong potential for improving reservoir
management. However, the response of a reservoir depends on many parameters and can be diffcult to understand and predict. Numerical modeling results integrating streamline fluid flow simulation, rock physics, and ray-Born seismic modeling address some of these problems. Calculations show that the sensitivity of amplitude changes to porosity depend on the type of sediment comprising the reservoir. For consolidated rock, high-porosity models show
larger amplitude changes than low porosity models. However, in an unconsolidated
formation, there is less consistent correlation between amplitude and porosity. The
rapid time-lapse modeling schemes also allow statistical analysis of the uncertainty in
seismic response associated with poorly known values of reservoir parameters such as
permeability and dry bulk modulus. Results show that for permeability, the maximum
uncertainties in time-lapse seismic signals occur at the water front, where saturation is most variable. For the dry bulk-modulus, the uncertainty is greatest near the
injection well, where the maximum saturation changes occur. Time-lapse seismic methods can also be applied to monitor CO2 sequestration.
Simulations show that since the acoustic properties of CO2 are very different from
those of hydrocarbons and water, it is possible to image CO2 saturation using seismic
monitoring. Furthermore, amplitude changes after supercritical fluid CO2 injection
are larger than liquid CO2 injection.
Two seismic surveys over Teal South Field, Eugene Island, Gulf of Mexico, were acquired at different times, and the numerical models provide important insights to understand changes in the reservoir. 4D seismic differences after cross-equalization
show that amplitude dimming occurs in the northeast and brightening occurs in the
southwest part of the field. Our forward model, which integrates production data,
petrophysicals, and seismic wave propagation simulation, shows that the amplitude
dimming and brightening can be explained by pore pressure drops and gas invasion, respectively.

Identiferoai:union.ndltd.org:tamu.edu/oai:repository.tamu.edu:1969.1/430
Date30 September 2004
CreatorsYuh, Sung H.
ContributorsGibson, Richard L., Jr.
PublisherTexas A&M University
Source SetsTexas A and M University
Languageen_US
Detected LanguageEnglish
TypeBook, Thesis, Electronic Dissertation, text
Format10783785 bytes, 140943 bytes, electronic, application/pdf, text/plain, born digital

Page generated in 0.0018 seconds