Return to search

On the Road to Graphene Biosensors

Biosensors are devices that detect biological elements and then transmit a readable signal. Biosensors can automatize diagnostics that would otherwise have to be performed by a physician or perhaps not be possible to perform at all. Current biosensors are however either limited to particular diseases or prohibitively expensive. In order to further the field, sensors capable of many parallel measurements at a lower cost need to be developed. Field effect transistor (FET) based sensors are possible candidates for delivering this, mainly by allowing miniaturization. Smaller sensors could be cheaper, and enable parallel measurements. Graphene is an interesting material to use as the channel of FET-sensors. The low electrochemical reactivity of its plane makes it possible to have graphene in direct contact with the sample liquid, which enhances the signal from impedance changes. Graphene-FET based impedance sensors should be able to sense almost all possible analytes and allow for scaling without losing sensitivity. In this work the steps needed to make graphene based biosensors are presented. An improved graphene transfer is described which by using low pressure to dry the graphene removes most contamination. A method to measure the contamination of graphene by surface enhanced Raman scattering is presented. Methods to produce double gated and electrolyte gated graphene transistors on a large scale in an entirely photolithographic process are detailed. The deposition of 1-pyrenebutyric acid (PBA) on graphene is studied. It is shown that at high surface concentrations the PBA stands up on graphene and forms a dense self-assembled monolayer. A new process of using Raman spectroscopy data to quantify adsorbents was developed in order to quantify the molecule adsorption. Biosensing has been performed in two different ways. Graphene FETs have been used to read the signal generated by a streaming potential setup. Using FETs in this context enables a more sensitive readout than what would be possible without them. Graphene FETs have been used to directly sense antibodies in high ionic strength. This sensing was done by measuring the impedance of the interface between the FET and the electrolyte.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-317092
Date January 2017
CreatorsHinnemo, Malkolm
PublisherUppsala universitet, Fasta tillståndets elektronik, Uppsala
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeDoctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess
RelationDigital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, 1651-6214 ; 1488

Page generated in 0.0021 seconds