The proposed vibration energy harvesting IC harvests energy from a piezoelectric transducer (PZT) to provide power for a wireless sensor node (WSN). With a traditional rectification stage, a two-path three-switch dual-input dual-output architecture is adopted to extract power and regulate the output voltage for the load with one stage. The power stage is controlled with a new maximum power point tracking (MPPT) algorithm, which integrates both fraction open circuit voltage (FOCV) and perturb and observe (PandO). The proposed algorithm was able to extract maximum power from a transducer due to high accuracy on the maxim power point (MPP) and low power dissipation.
The proposed circuit is implemented in TSMC 180 nm BCD technology and the post-layout simulation verifies the functionality of the proposed design. The simulation results show that the circuit operates under the maximum power point to extract maximum power from a PZT. / Master of Science / The battery life has always been problematic ever since electronic devices exist. As semiconductor technology advances, more transistors could fit in the same area. Resultantly, portable, and mobile devices become more powerful but usually dissipate more power. Unfortunately, the development of the batteries has not been improved significantly. So, it is necessary to charge portable and mobile devices often or replace batteries frequently. In some applications where a device is hard to reach once installed, charging or replacing the battery is difficult. Under these circumstances, energy harvesting from ambient sources is an effective alternative.
There are many types of sources of energy widely available in the environment such as vibration, thermal, solar, RF and etc. Solar energy harvesting is the most popular owing to high power density. However, sunlight is unavailable during night time. Vibration energy, although the power density is lower compared with solar, is a viable solution when solar is not a good source of energy.
The proposed work utilizes abundant vibration energy at factories to power wireless sensor nodes (WSNs), which can monitor the temperature, light intensity, pressure, etc.
| Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/106734 |
| Date | 02 June 2020 |
| Creators | Li, Jiayu |
| Contributors | Electrical Engineering, Ha, Dong S., Yi, Yang, Sable, Daniel M. |
| Publisher | Virginia Tech |
| Source Sets | Virginia Tech Theses and Dissertation |
| Detected Language | English |
| Type | Thesis |
| Format | ETD, application/pdf |
| Rights | In Copyright, http://rightsstatements.org/vocab/InC/1.0/ |
Page generated in 0.0011 seconds