This research thesis presents an analysis of the torsional loads on V-band clamps. In some applications, the relative rotational movement of the flanges connected by V-band clamps can result in catastrophic system failure. The ability to understand the factors impacting on torsional load capacity is therefore essential. In this research project, a theoretical model of a V-band joint subjected to torsional loads was developed. This model is used to identify those parameters that will impact on the joint’s reliability. An experimental investigation was conducted to validate a theoretical model using a newly developed test rig. The development and features of this test rig are presented in this report. This experimental investigation also allowed the impact of those parameters that are difficult to control, to be determined. A total of three V-bands were used with different diameters but nominally identical cross sections were studied. In the research results, the initial slip point between flanges and the V-band clamp was identified by experimentation within this research project. Different sizes of Vbands were used under boundary conditions and loads. From the simulation results it was determned that the friction effect on the V-band depends on the size of the V-band. For the largest size of V-band, there was moderate correlation of the experimental and theoretical results. For the smallest size, the results suggest that with band tightening, flange contact is localised, rather than being throughout the band’s entire circumference. The research demonstrated the significant relevance of the band and flanges’ contact points and the coefficient of friction, especially that between the flanges, on the V-band clamp’s theoretical torsional load capacity.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:686196 |
| Date | January 2015 |
| Creators | Sahboun, Salahaddin |
| Contributors | Barrans, Simon |
| Publisher | University of Huddersfield |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://eprints.hud.ac.uk/id/eprint/28321/ |
Page generated in 0.0019 seconds