Injection molding is a high rate production process for manufacturing plastic parts. There is often a conflict between good appearance and short cycle time. Injection molded parts can show several types of surface defect. It is believed that wall slip may be associated with some types of defect, because wall slip can modify the distributions of velocity, wall shear stress, pressure and heat flux. The work described here involves an experimental study of the occurrence of flow marks during injection molding of linear polyethylene, and the possible relationship between these defects and wall slip. It also involves the investigation of the feasibility of incorporating wall slip models in the 2.5D computer simulation of the injection molding process.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:QMM.23745 |
| Date | January 1996 |
| Creators | Heuzey, Marie-Claude |
| Contributors | Dealy, John M. (advisor) |
| Publisher | McGill University |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Format | application/pdf |
| Coverage | Master of Engineering (Department of Chemical Engineering.) |
| Rights | All items in eScholarship@McGill are protected by copyright with all rights reserved unless otherwise indicated. |
| Relation | alephsysno: 001499568, proquestno: MM12117, Theses scanned by UMI/ProQuest. |
Page generated in 0.0017 seconds