Increasing demands for lower carbon dioxide emissions and fuel consumption drive technological developments for car manufacturers. One trend that has shown success for reducing fuel consumption in spark ignited engines is downsizing, where the engine size is reduced to save fuel and a turbocharger is added to maintain the power output. A drawback of this concept is the slower torque response of a turbocharged engine. Recent hardware improvements have facilitated the use of variable geometry turbochargers (VGT) for spark ignited engines, which can improve the transient torque response. This thesis addresses the transient torque response through three papers. Paper 1 presents the optimal control of the valve timing and VGT for a fast torque response. Optimal open-loop control signals are found by maximizing the torque integral for a 1-d simulation model. From the optimization it is found that keeping the ratio between exhaust and intake pressure at a constant level gives a fast torque response. This can be achieved by feedback control using vgt actuation. The optimal valve timing differs very little from a fuel consumption optimal control that uses large overlap. Evaluation on an engine test bench shows improved torque response over the whole low engine speed range. In Paper 2, model based, nonlinear feedback controllers for the exhaust pressure are presented. First, the dynamic relation between requested VGT position and exhaust pressure is modeled. This model contains an estimation of the on-engine turbine flow map. Using this model, a controller based on inverting the input-output relation is designed. Simulations and measurements on the engine show that the controller handles the strong nonlinear characteristic of the system, maintaining both stability and performance over the engine’s operating range. Paper 3 considers the dependence of the valve timing for the cylinder gas exchange process and presents a torque model. A data-based modeling approach is used to find regressors, based on valve timing and pressures, that can describe the volumetric efficiency for several engine speeds. Utilizing both 1-d simulations and measurements, a model describing scavenging is found. These two models combine to give an accurate estimation of the in-cylinder lambda, which is shown to improve the torque estimation. The models are validated on torque transients, showing good agreement with the measurements. / <p>QC 20120928</p>
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:kth-102743 |
| Date | January 2012 |
| Creators | Flärdh, Oscar |
| Publisher | KTH, Reglerteknik, KTH, ACCESS Linnaeus Centre, Stockholm |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Doctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
| Relation | Trita-EE, 1653-5146 ; 2012:031 |
Page generated in 0.003 seconds