Thesis submitted in partial fulfilment of the requirements for the degree
Magister Technologiae: Electrical Engineering
in the Faculty of Engineering
at the Cape Peninsula University of Technology
2013 / The space environment is characterised by harsh radiation, extreme temperatures and
vacuum. Electronics subsystems for satellite applications are designed to be fault tolerant
and robust enough to survive this environment. A power distribution module (PDM) for a
CubeSat nanosatellite application is developed here, with the aim to distribute power to
CubeSat subsystems reliably. The PDM prototype is carefully designed with reference to an
extensive literature study. The study dwells on the low Earth orbit (LEO) space environment,
critically identifying radiation sources and temperature ranges in the LEO. The study further
investigates traditional analogue techniques of logic circuit design using bipolar junction
transistors (BJTs) which are known for their higher tolerance to radiation sources as
compared to recent integrated circuits (ICs). Careful consideration is given to different ways
of designing a fault tolerant system. The study specifically looks at redundant circuit design
within the limitations of weight and space of a nanosatellite. Possible electrical faults in
power systems are identified, which include over-currents, over-voltages, over-temperatures,
inrush currents and latchup. This study shows that identified faults generally are overcurrents.
A power switch is included in each power distribution channel to trip the current in
case a faulty condition is detected. The PDM is designed to have eight power output
distribution channels to allow a subsystem load to connect to more than one channel,
thereby meeting its power requirements. The PDM power channels are designed identically.
Upon application, current limits are selected by a two-resistor divider circuit and connectors
are used to connect to a required voltage bus at manufacturing time. The system’s
functionality is tested and verified using an Arduino development board interfaced to all I2C
devices as a master node, typically the on-board computer (OBC) in a real satellite mission.
The system’s functionality in a Gamma irradiated laboratory environment is verified to
perform as required. The PDM system is further tested in a temperature cycled chamber
from -31°C to 61°C. The system survived the entire eight hour test duration of two cycles. It
is observed that the system is fault tolerant to radiation sources up to 10 krad and the
temperature limits mentioned. The PDM system is recommended as an additional module to
the CubeSat electrical power subsystem (EPS), thereby improving the reliability of the power
subsystem.
Keywords: CubeSat, power channel, module, radiation, reliability, efficiency, I2C, prototype.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:cput/oai:localhost:20.500.11838/1073 |
| Date | January 2013 |
| Creators | Maleka, Motlokwe |
| Publisher | Cape Peninsula University of Technology |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Rights | http://creativecommons.org/licenses/by-nc-sa/3.0/za/ |
Page generated in 0.0024 seconds