The challenges in the deposition of dissimilar materials are mainly related to the large differences in the physical and chemical properties of the deposited and substrate materials. These differences readily cause residual stresses and intermetallic phases. This has led to the development of functionally graded materials which exhibit spatial variation in composition. Laser direct metal deposition due to its flexibility, it offers wide variety of dissimilar and functionally graded materials deposition. Despite considerable advances in process optimization, there is a rather limited understanding of the role of metallurgical factors in the laser deposition of dissimilar and functionally graded alloys. The aim of this work is to understand and explain mechanisms occurring in diode laser deposition of dissimilar materials and functionally graded materials. The first part of this work addressed diode laser deposition of Inconel 718 nickel alloy to Ti-6Al-4V titanium alloy. Here, the effect of laser pulse parameters and powder mass flow rates on the stress formation and cracking has evaluated by experiment and numerical techniques. Results showed that the clad thickness was an important factor affecting the cracking behaviour. In the second part of this study, an image analysis technique has been developed to measure the surface disturbance and the melt pool cross section size during laser direct metal deposition of Inconel 718 on a Ti-6Al-4V thin wall. It was noted that under tested conditions the overall melt pool area increased with the increase in powder flow rate; the powder carrier gas flow rates also seemed to play important roles in determining the melt pool size. In the third part of this study, a parametric study on the development of Inconel 718 and Stainless steel 316L continuously graded structure has been carried out. Results suggested that microstructure and other mechanical properties can be selectively controlled across the deposited wall. The results presented in this dissertation can be used as a metallurgical basis for further development of dissimilar and functionally graded manufacturing using LDMD technique, guiding future manufacturing engineers to produce structurally sound and microstructurally desirable laser deposited samples.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:542734 |
| Date | January 2011 |
| Creators | Shah, Kamran |
| Contributors | Li, Lin |
| Publisher | University of Manchester |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | https://www.research.manchester.ac.uk/portal/en/theses/laser-direct-metal-deposition-of-dissimilar-and-functionally-graded-alloys(baa5f8fd-cead-4047-afbf-860844b501d8).html |
Page generated in 0.0019 seconds