Return to search

Investigation of a stop-fold tiltrotor

In 1967 the US Air Force solicited proposals for ``low-disc-loading [Vertical Takeoff and Landing] configurations suitable for high speed flight.' Bell Helicopter elected to respond with a proposal after initial analysis on configurations including a stopped edgewise disc and a trail rotor. They concluded that a folding proprotor design would best meet the requirements laid forth. Initial analysis work began on this folding proprotor (stop-fold) design in the same year and concluded in 1972 with a full scale 25 foot diameter pylon and rotor assembly wind tunnel test at the NASA-Ames Large Scale Wind Tunnel. The project was concluded at this point and never resulted in a production or research aircraft.

The original proposed stop-fold tiltrotor design by Bell Helicopter allowed for vertical takeoff and landing, a transition sequence rotating the pylon rotor assembly from helicopter to airplane mode, a conversion sequence during which the rotor stopped and blades folded along the pylon, and a transition from prop thrust to auxiliary jet engine power while the rotor was being stopped. This configuration effectively removes the high-speed restraints typical of a prop-driven aircraft and instead opens a flight envelope comparable to a fixed-wing jet.

This project entails both the simulation and basic analysis of the stop-fold concept with special attention to frequency responses and potential coupling between modes.

Identiferoai:union.ndltd.org:GATECH/oai:smartech.gatech.edu:1853/29662
Date09 July 2009
CreatorsBosworth, Jeff
PublisherGeorgia Institute of Technology
Source SetsGeorgia Tech Electronic Thesis and Dissertation Archive
Detected LanguageEnglish
TypeThesis

Page generated in 0.0018 seconds