The aerodynamics of bodies in compressible ground effect flowfields from low-subsonic to supersonic Mach numbers have been investigated numerically and experimentally. A study of existing literature indicated that compressible ground effect has been addressed sporadically in various contexts, without being researched in any comprehensive detail. One of the reasons for this is the difficulty involved in performing experiments which accurately simulate the flows in question with regards to ground boundary conditions. To maximise the relevance of the research to appropriate real-world scenarios, multiple bodies were examined within the confines of their own specific flow regimes. These were: an inverted T026 wing in the low-to-medium subsonic regime, a lifting RAE 2822 aerofoil and ONERA M6 wing in the transonic regime, and a NATO military projectile at supersonic Mach numbers. Two primary aims were pursued. Firstly, experimental issues surrounding compressible ground effect flows were addressed. Potential problems were found in the practice of matching incompressible Computational Fluid Dynamics (CFD) simulations to wind tunnel experiments for the inverted wing at low freestream Mach numbers (<0.3), where the inverted wing was found to experience significant compressible effects even at Mach 0.15. The approach of matching full-scale CFD simulations to scale model testing at an identical Reynolds number but higher Mach number was analysed and found to be prone to significant error. An exploration was also conducted of appropriate ways to conduct experimental tests at transonic and supersonic Mach numbers, resulting in the recommendation of a symmetry (image) method as an effective means of approximating a moving ground boundary in a small-scale blowdown wind tunnel. Issues of scale with regards to Reynolds number persisted in the transonic regime, but with careful use of CFD as a complement to experiments, discrepancies were quantified with confidence. The second primary aim was to use CFD to gain a broader understanding of the ways in which density changes in the flowfield affect the aerodynamic performance of the bodies in question, in particular when a shock wave reflects from the ground plane to interact again with the body or its wake. The numerical approach was extensively verified and validated against existing and new experimental data. The lifting aerofoil and wing were investigated over a range of mid-to-high subsonic Mach numbers (1>M???>0.5), ground clearances and angles of incidence. The presence of the ground was found to affect the critical Mach number, and the aerodynamic characteristics of the bodies across all Mach numbers and clearances proved to be highly sensitive to ground proximity, with a step change in any variable often causing a considerable change to the lift, moment and drag coefficients. At the lowest ground clearances in both two and three dimensional studies, the aerodynamic efficiency was generally found to be less than that of unbounded (no ground) flight for shock-dominated flowfields at freestream Mach numbers greater than 0.7. In the fully-supersonic regime, where shocks tend to be steady and oblique, a supersonic spinning NATO projectile travelling at Mach 2.4 was simulated at several ground clearances. The shocks produced by the body reflected from the ground plane and interacted with the far wake, the near wake, and/or the body itself depending on the ground clearance. The influence of these wave reflections on the three-dimensional flowfield, and their resultant effects on the aerodynamic coefficients, was determined. The normal and drag forces acting on the projectile increased in exponential fashion once the reflections impinged on the projectile body again one or more times (at a height/diameter ground clearance h/d<1). The pitching moment of the projectile changed sign as ground clearance was reduced, adding to the complexity of the trajectory which would ensue.
| Identifer | oai:union.ndltd.org:ADTP/272641 |
| Date | January 2009 |
| Creators | Doig, Graham , Mechanical & Manufacturing Engineering, Faculty of Engineering, UNSW |
| Publisher | Awarded by:University of New South Wales. Mechanical & Manufacturing Engineering |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | Copyright Doig Graham ., http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0017 seconds