Return to search

Experimental and numerical investigation of transonic turbine cascade flow

A comprehensive study of the flowfield through a two-dimensional cascade of the high pressure turbine blades of a jet engine is presented. The main interest is the measurement and prediction of the mass-averaged total pressure losses. Other experiments, such as flow visualization, are aimed at the validation of the code that was used to obtain the numerical results and also to further knowledge about the details of the loss generation. The experimental studies were carried out on a cascade of eleven blades in a blow-down tunnel. Total pressure measurements were taken upstream of the cascade and also by traversing on downstream planes. The static pressures needed for the mass averaging and the probe bow shock correction were obtained by pressure taps on the cascade tunnel side wall. The static pressure was also measured on the surface of some instrumented blades. Shadowgraph pictures were taken for study of the trailing edge shock structure and for the turbulent transition location. A single-plate interferometer technique was used for density field measurements. The major goal of the numerical studies was the prediction of the mass-averaged total pressure losses, but all other measured quantities were also generated from the computed flowfield. A critical issue was the generation of a proper grid. For the studied type of flow, a non-periodic C-type grid turned out to be the most advantageous. For use in the moderately compressible attached turbulent boundary layer, a Clauser-type eddy viscosity model was developed and tested. In the trailing edge and wake region, the Baldwin-Lomax model was used. Good agreement of calculations and measurements was obtained for the blade surface and cascade tunnel side wall static pressures, the trailing edge shock structure, and the density field. The agreement between the measured and calculated total pressure drop profiles was not quite as good; however, that quantity is known to be difficult to predict accurately. The mass-averaged total pressure loss coefficient, calculated from the total pressure drop profiles, was again in good agreement with the measurements. The difference between the measured and computed total pressure drop profiles suggested that the Baldwin-Lomax model underpredicted the eddy viscosity in the trailing edge region. / Ph. D.

Identiferoai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/37273
Date02 February 2007
CreatorsKiss, Tibor
ContributorsAerospace Engineering, Schetz, Joseph A., Moses, Hal L., Grossman, Bernard M., Walters, Robert W., Ng, Fai
PublisherVirginia Tech
Source SetsVirginia Tech Theses and Dissertation
LanguageEnglish
Detected LanguageEnglish
TypeDissertation, Text
Formatxix, 291 leaves, BTD, application/pdf, application/pdf
RightsIn Copyright, http://rightsstatements.org/vocab/InC/1.0/
RelationOCLC# 27880873, LD5655.V856_1992.K577.pdf

Page generated in 0.0019 seconds