A novel design, material, and fabrication method are presented to fabricate a
passive micro-ball valve. Microvalves are critical components in microflow
control devices used to control the fluid flows in microchannels. These microflow
control devices can be integrated with microsensors to form micro analysis
systems. Glass/silicon-based fabrication is complicated and expensive. Therefore,
other materials and fabrication methods have been proposed. In this research,
Melinex 453, a polyester film, and pressure sensitive adhesives were used to
fabricate a micro-ball valve by a microlamination method.
The valve was designed to have a 450 μm diameter glass ball floating inside a
chamber size of 800 μm. The ball will permit flow in the forward direction and
impede flow in the reverse direction. The fabrication method consists of three
steps: patterning, registration and bonding. The patterning step was accomplished
using laser micromachining. Registration and bonding were performed with the use
of a pin-alignment fixture. Pressure sensitive adhesive was used in the bonding step
using double-sided acrylic adhesive tape. The micro-ball valve has advantages over
other microvalves in terms of little dead volume, simple design, disposability, low
operating pressure in forward direction, and low leakage in reverse direction.
The micro-bal1 valve was characterized by pressure drop testing at different
flow rates from 1 to 7.5 ml/min. The experimental results tend to agree with a
simple theoretical model of the pressure drop through an orifice. Moreover, an
average pressure drop diodicity of at least 2980 has been achieved. / Graduation date: 2002
| Identifer | oai:union.ndltd.org:ORGSU/oai:ir.library.oregonstate.edu:1957/28772 |
| Date | 19 October 2001 |
| Creators | Wangwatcharakul, Worawut |
| Contributors | Paul, Brian K. |
| Source Sets | Oregon State University |
| Language | en_US |
| Detected Language | English |
| Type | Thesis/Dissertation |
Page generated in 0.0019 seconds