Sedimentation is a fundamental operation in wastewater treatment works. A rational design
of sedimentation tanks is currently achieved by plotting iso-percentile (iso-percentage)
concentration removal profiles from flocculent settling data. A major drawback of the
graphical iso-percentage method is that the iso-percentile lines are often manually
interpolated and are mere hand drawn estimations. This is because the settling behaviour of
sludge particles is highly non-linear. The manual analytical process is therefore very tedious,
inaccurate and subjective. Hence, an optimised design of sedimentation tanks is necessary in
order to eliminate the errors incurred during data analysis.
In this study, a mechanistic iso-percentile flocculent model (referred to as the velocity
flocculation model) is developed to simulate the behaviour of flocculating colloidal particles
in turbid water. This model is based on the physical meanings of flocculent settling particles
and on fractal theory. It is formulated to produce automated iso-percentile curves which are
fundamental in the design of sedimentation tanks.
The iso-percentile model was vertically integrated into a velocity model to produce a model
expressing the velocity of particles as a function of removal rate. The velocity model has an
obvious advantage over the iso-percentile model in that it is easy to contextualize. It can be
reverted back to the iso-percentile trajectory analysis eliminating the need for extensive data
interpolation and may in future eliminate the need for settling column analysis altogether. In
the current study, the integrated velocity form is used to predict instantaneous flocculent
settling velocity of fine suspended particles under near quiescent conditions. This is vital
since it is difficult to obtain velocity values in-situ or directly from sedimentation tanks.
Model validity and competency was tested by a direct comparison with existing literature
models, such as Ozer’s model and Ramatsoma and Chirwa’s model. Model comparison was
based on the goodness of fit, the least sum of square errors and mathematical consistency
with known flocculent settling behaviour. The newly developed iso-percentile model
achieved a more accurate simulation of physical experimental data, did not violate any of the
mathematical constraints and yielded lower sum of square errors than originally achieved by
Ozer and Ramatsoma and Chirwa. Notably, the proposed velocity model offers a distinctive advantage over conventional
interpolated-iso-percentile based models which are prone to numerical errors during
interpolation. Its performance (velocity model) was compared against Je and Chang’s
velocity model. Higher velocity values were observed for the new model than for Je and
Chang’s model implying that empirically based models would tend to under-predict the
velocity values. The model developed in this study brings us one step closer to achieving full
automation of the settling tank and clarifier design. / Dissertation (MEng)--University of Pretoria, 2013. / gm2014 / Chemical Engineering / unrestricted
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:up/oai:repository.up.ac.za:2263/40841 |
| Date | January 2013 |
| Creators | Sithebe, Nomcebo Princess |
| Contributors | Chirwa, Evans M.N., cebosithebe@yahoo.com |
| Publisher | University of Pretoria |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Dissertation |
| Rights | © 2013 University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria. |
Page generated in 0.0018 seconds