Cross flow wind turbines are not unique. The performance of Savonius and Darrieus turbines is well documented. Both share the advantage of being able to accept fluid flow from any direction. The Savonius is drag based and hence has poor power output while the Darrieus is lift based. Due to the fact that the Darrieus has fixed blades the fluid flow through the rotor does not result in optimal lift being generated at all points in the rotation circle. A drawback of the Darrieus system is that it has to operate at a high tip-to wind-speed ratio to obtain reasonable performance with the fixed blades. Deviation from a small optimal range of tip speed ratios results in poor performance. The Darrieus also has poor starting torque. The research conducted in this project focused on overcoming the shortcomings of other turbines and developing an effective cross flow turbine capable of good performance. A number of different concepts were experimented with, however all were based on a symmetrical aerofoil presented to the actual relative airflow at an angle that would produce the highest lift force at all times. The lift force was then utilized to generate movement and to do work on an electrical generator. All concepts contemplated were researched to ascertain their appropriateness for the intended application. During development of the final experimental platform and after lodging of a provisional patent (RSA 2007/00927) it was ascertained that the design shared some similarities with an American patent 5503525 dated 28/4/1994. This patent employed complex electronic sensing and control equipment for control of blade angle. This was thought to be overly complex and costly, particularly for small scale wind energy generation applications and a simpler mechanical solution was sought in the design of the final experimental platform used in this project. The design of the mechanical control system was refined in an attempt to make it simpler, more durable and employ the least number of moving parts. Literature studies and patent searches conducted, suggested that the mechanical control system as developed for the final experimental platform was unique. The enormous variation in the power available from the wind at the different wind speeds likely to be encountered by the device necessitated some means of control. In high wind conditions control of the amount of wind power into the device was deemed to be the preferable means of control. A number of different concepts to achieve this were devised and tested. The final concept employed limited the tail angle deflection and hence the lift produced by the aerofoils. This resulted in a seamless “throttle” control allowing the device to be used in any wind strength by adjusting the control to a position that resulted in the device receiving a suitable amount of power from the wind. The outcome of performance tests conducted indicated that the device has the potential to be developed into a viable wind turbine for both small and large scale applications. The ability to control the power input from the wind to the machine from zero to a maximum is considered to be one of the most beneficial outcomes of this project and together with the quiet operation and low speed, are considered the main advantages of the device over existing wind turbine designs. The possibilities of using the device to compress air for energy storage are exciting avenues that warrant further research.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:nmmu/vital:9622 |
| Date | January 2008 |
| Creators | Phillips, Russell Leslie |
| Publisher | Nelson Mandela Metropolitan University, Faculty of Engineering, the Built Environment and Information Technology |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis, Doctoral, DTech |
| Format | xviii, 144 leaves, pdf |
| Rights | Nelson Mandela Metropolitan University |
Page generated in 0.002 seconds