Reinforced concrete shear walls as seismic force resisting systems may experience inelastic deformations if subjected to strong seismic excitations. These walls are designed to provide strength, stiffness, energy dissipation capacity and lateral drift control for seismic resistance. Shear wall deformability is largely dependent on adequate confinement of core concrete in boundary elements, prevention of longitudinal bar buckling, as well as proper design and detailing of the web section.
Conventional transverse reinforcement placed in shear wall boundary elements consists of hoops, overlapping hoops and crossties, based on the geometry and number of longitudinal bars used. The confinement steel requirement of current building codes (ACI 318 or CSA A23.3) often results in congestion of steel cage due to the high transverse reinforcement ratio required. Placing multiple hoops with 135-degree bends combined with crossties to satisfy the code confinement requirements can create concrete placement and construction problems. In addition, the required time to assemble conventional steel cages with multiple individual ties per spacing can be time consuming, potentially impacting the overall cost and duration of construction.
Welded Wire Reinforcement (WWR) is available in the construction industry as concrete reinforcement in the form of welded wire fabric (WWF) manufactured from relatively small diameter wires in comparison to the bar sizes typically used in structural applications. As an alternative to using conventional transverse hoops, prefabricated WWR grids can be used to provide required transverse reinforcement in boundary elements. WWR grids are manufactured using robots to weld cut steel pieces accurately before they are shipped to the job site, resulting in better construction quality and reduced construction time. However, research on the use of WWR is limited in the literature. Further experimental and analytical research is needed to establish design requirements for such reinforcement, especially when used in earthquake resistant construction with requirements for ductile response.
The current research project, involved three main phases; i) tests of 3 large-scale reinforced concrete shear walls with WWR grids used as boundary element transverse reinforcement, ii) material tests of grid samples, including those cast in concrete, iii) non-linear finite element analysis. The wall tests were conducted under slowly-applied lateral deformation reversals to investigate their strength and ductility for suitability as seismic resistant structural elements. Material tests were conducted to have a better understanding of WWR behavior, especially their weld capacity. Analytical research was undertaken to expand the experimental findings on shear wall behavior, as well as to conduct parametric investigation to understand the impact of changes in grid strength and ductility.
The results indicated that WWR grids can be used as boundary element transverse reinforcement in earthquake resistant shear wall. However, strength and ductility of grids should be established carefully prior to such application. Design strength of WWR grids should be established through burst tests to ensure ductile yielding of wire reinforcement prior to premature weld failure. Those grids that exhibit weld failures may be used with reduced design strength to permit the development of sufficient inelastic deformability in flexure-dominant shear walls.
| Identifer | oai:union.ndltd.org:uottawa.ca/oai:ruor.uottawa.ca:10393/37702 |
| Date | 15 May 2018 |
| Creators | Navidpour, Mansour |
| Contributors | Saatcioglu, Murat |
| Publisher | Université d'Ottawa / University of Ottawa |
| Source Sets | Université d’Ottawa |
| Language | English |
| Detected Language | English |
| Type | Thesis |
| Format | application/pdf |
Page generated in 0.0021 seconds