<p>Two different solution heat treatments (2hours at 570ºC and 10minutes at 520ºC) have been used to study precipitation in two 6xxx (Al-Mg-si) dispersoid-freealloys with composition: 0.721 at % Si, 0.577 at % Mg (alloy A3) and 0.57 at %Si 0.72 at % Mg (alloy A12). The relation between their microstructure and macroscopical properties such as hardness and ductility has been investigated. Tensile tests, hardness measurements, electrical conductivity sigma tests, grain size measurements in optical microscope and microstructure characterization in Transmission Electron Microscope (TEM) have all been done. The effect of alloy composition and solution heat treatment temperature and time on the microstructure and the resulting macroscopical properties (hardness, yield stress, tensile strength and ductility) was investigated. The results indicate that when alloy A3 is solution treated at 520ºC for 10 minutes and then annealed for 3 hours at 175ºC, its hardness, yield stress and tensile strength as well as ductility is optimised i.e.A3 has better mechanical properties and low cost of production at these conditions. It has been proved that the strengthening was solely due to precipitation particles and not grain size.</p>
| Identifer | oai:union.ndltd.org:UPSALLA/oai:DiVA.org:ntnu-658 |
| Date | January 2003 |
| Creators | Mageto, Maxwell Joel |
| Publisher | Norwegian University of Science and Technology, Department of Physics |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Student thesis, text |
Page generated in 0.0022 seconds