A specially-designed plasma chamber was constructed to study the operating characteristics of a dc plasma transferred arc struck between a fluid convective cathode and a water-cooled anode. The plasmagen gas consisted of pure argon and arc lengths as high as 7 cm were studied. / The arc voltage increased markedly with arc length and with an increase in the inlet velocity of the argon flow past the cathode tip, and much less with an increase in current. The effect of the gas velocity was minor at low velocities (1 to 3 m/s) but became important at higher velocities (20 to 60 m/s). / Arc length and gas velocity were again the major factors in the distribution of the arc energy. For long arcs and at high gas velocities, the energy emitted by the arc to the wall of the chamber was dominant, while for short arcs the energy absorbed by the water-cooled anode was greater. In all cases, the fraction of the input energy absorbed by the water-cooled cathode, or leaving the system as sensible heat in the exit gas was small. At the anode, the major contribution was from electron recombination, with convection heat transfer from the plasma somewhat less. Direct radiation from the plasma to the anode surface was very small. The recombination of the electron stream occurred on a very small area of the anode ((TURN) 5 mm in diameter). In spite of the energetic water cooling, appreciable vaporization took place on that area. / Appropriate instrumentation permitted the measurement of the stagnation-pressure and pressure distribution on the anode, and that of total heat flux and radiative heat transfer. From the latter, it was estimated that the plasma temperature just above the anode was in the range 10,000 - 12,000 K. / Preliminary experiments with an anode consisting of molten copper showed that the arc root was no longer fixed, but moved around continuously. The arc was otherwise quite stable, and its operating characteristics differed little from those reported for solid anodes, in spite of the greater extent of metal vaporization.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:QMM.68548 |
| Date | January 1980 |
| Creators | Choi, H. K. (Hyun Koo), 1947- |
| Publisher | McGill University |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Format | application/pdf |
| Coverage | Doctor of Philosophy (Department of Chemical Engineering) |
| Rights | All items in eScholarship@McGill are protected by copyright with all rights reserved unless otherwise indicated. |
| Relation | alephsysno: 000114585, proquestno: AAINK51907, Theses scanned by UMI/ProQuest. |
Page generated in 0.0025 seconds