Return to search

Advanced Microfabrication Techniques for the Development of Microfluidic-Based Artificial Placenta-Type Lung Assist Device

Preterm infants are at risk for respiratory distress syndrome (RDS) due to immature lungs, leading to notable neonatal mortality. About 10% of US births are premature. While mechanical ventilation is a common RDS treatment, it can cause complications. If it fails, extracorporeal membrane oxygenation (ECMO) is employed, but standard ECMO devices are not suited for preterm babies. The limitations of hollow fiber membrane oxygenators used in ECMO have spurred interest in an artificial placenta that connects to the umbilical cord and supports lung growth. Microfluidic blood oxygenators, with their biomimetic designs, have being explored for this purpose. This thesis advances microfabrication techniques for Lung Assist Devices (LADs), focusing on two main objectives: I. Improving Throughput for Elevated Blood Flow Rates: This section delves into refining Microfluidic Blood Oxygenators (MBOs) to accommodate greater blood flow rates. By combining parallel units, we increased throughput and optimized LAD designs. Newly designed MBOs, with an expanded gas exchange surface area, can manage blood flow rates up to 60 mL/min. Using these enhanced MBOs, we constructed a novel LAD achieving superior oxygenation compared to predecessors. Our in vitro tests confirmed that this LAD can sustain blood flow rates of up to 150 ml/min, elevating oxygen saturation by approximately 20%—equivalent to an oxygen transfer of 7.48 mL/min, a leading figure for AP-type devices. II. Hierarchically Designed Microchannels: The second objective revolves around developing microchannels with a hierarchical layout to mitigate stagnation and high shear stress regions. Traditional photolithography poses challenges at channel intersections, inducing clotting risks. We pioneered alternative microfabrication methods, yielding diverse microchannels and intricate hierarchical designs that emulate natural vascular networks devoid of dead zones. These advancements have propelled the microfabrication domain for artificial placenta-like LADs. Utilizing our method, we produced channels varying from hundreds to a few microns in height with a single exposure and an opal diffuser. Thin membranes (~60 µm top and ~45 µm bottom) were amalgamated, culminating in a total depth of about 200 µm. Such oxygenators excel in oxygenating blood even at intense flow rates of up to 15 mL/min per unit. Leveraging these hierarchically designed MBOs, we crafted a LAD supporting a flow rate of 100 mL/min, offering an oxygen transfer of 5.21 mL/min. Both LADs developed in this research proficiently support premature neonates weighing up to 2 kg. Notably, the priming volume of the LAD using the enhanced MBOs has been substantially minimized, underscoring its advancements over earlier models. Realizing these objectives can transform neonatal care, addressing respiratory challenges in premature neonates and bolstering their chances for a healthier life. / Thesis / Master of Science (MSc)

Identiferoai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/29117
Date11 1900
CreatorsSaraei, Neda
ContributorsSelvaganapathy, Dr. P. Ravi, Biomedical Engineering
Source SetsMcMaster University
LanguageEnglish
Detected LanguageEnglish
TypeThesis

Page generated in 0.0019 seconds