Return to search

Wall Heat Transfer Effects In The Endwall Region Behind A Reflected Shock Wave At Long Test Times

Shock-tube experiments are typically performed at high temperatures (≥1200K) due to test-time constraints. These test times are usually ~1 ms in duration and the source of this short, test-time constraint is loss of temperature due to heat transfer. At short test times, there is very little appreciable heat transfer between the hot gas and the cold walls of the shock tube and a high test temperature can be maintained. However, some experiments are using lower temperatures (approx. 800K) to achieve ignition and require much longer test times (up to 15 ms) to fully study the chemical kinetics and combustion chemistry of a reaction in a shock-tube experiment. Using mathematical models, analysis was performed studying the effects of temperature, pressure, shock-tube inner diameter, and test-port location at various test times (from 1 - 20 ms) on temperature maintenance. Three models, each more complex than the previous, were used to simulate test conditions in the endwall region behind the reflected shock wave with Ar and N2 as bath gases. Temperature profile, thermal BL thickness, and other parametric results are presented herein. It was observed that higher temperatures and lower pressures contributed to a thicker thermal boundary layer, as did shrinking inner diameter. Thus it was found that a test case such as 800K and 50 atm in a 16.2-cm-diameter shock tube in Argon maintained thermal integrity much better than other cases - pronounced by a thermal boundary layer ≤ 1 mm thick and an average temperature ≥ 799.9 K from 1-20 ms.

Identiferoai:union.ndltd.org:ucf.edu/oai:stars.library.ucf.edu:etd-4163
Date01 January 2007
CreatorsFrazier, Corey
PublisherSTARS
Source SetsUniversity of Central Florida
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
SourceElectronic Theses and Dissertations

Page generated in 0.0026 seconds