Dielectric thin films have a long history in silicon photovoltaics. Due to the specific physical properties, they can function as passivation layer in solar cells. Also, they can be used as antireflection coating layers on top of the devices. They can improve the back surface reflectance if proper dielectric layers combination is used. What??s more, they can protect areas by masking during chemical etching, diffusion, metallization among the whole fabrication process. Crystalline silicon solar cell can be passivated by two ways: one is to deposit dielectric thin films to saturate the dangling bonds; the other is to introduce surface electrical field and repel back the minority carriers. This thesis explores thermally grown SiO2 and sputtered Si3N4(:H) to passivate n-type and thermal evaporation AlF3 to passivate p-type Float Zone silicon wafers, respectively. Sputtering is a cheap passivation method to replace PECVD in industry usage, but all sputtered samples are more likely to have encountered surface damage from neutral Ar and secondary electrons, both coming from the sputtered target. AlF3/SiO2 multi-layer stack is a negative charge combination; p inversion layer will form on the wafer surface. Light trapping is an important part in solar cell research work. In order to enhance the reflectance and improve the absorption possibility of near infrared photons, especially for high efficiency PERL cell application, the back surface structure is optimized in this work. Results show SiO2/Ag is a very good choice to replace SiO2/Al back reflectors. The maximum back surface reflectance is 97.82%. At the same time, SiO2/Ag has excellent internal angle dependence of reflectance, which is beneficial for surface textured cells. A ZnS/MgF2/SiO2/Al(Ag) superlattice can improve the back reflectance, but it is sensitive to incident angle inside the silicon wafer. If planar wafers are used to investigate all kinds of back reflectors, and an 8 degrees incident angle is fixed for typical spectrometry measurement, the results are easy to predict by Wvase software simulation. If a textured surface is considered, the light path inside the silicon wafer is very complicated and hard to calculate and simulate. The best way to evaluate the result is through experiment.
Identifer | oai:union.ndltd.org:ADTP/272549 |
Date | January 2009 |
Creators | Song, Yang, Photovoltaics & Renewable Energy Engineering, Faculty of Engineering, UNSW |
Publisher | Publisher:University of New South Wales. Photovoltaics & Renewable Energy Engineering |
Source Sets | Australiasian Digital Theses Program |
Language | English |
Detected Language | English |
Rights | http://unsworks.unsw.edu.au/copyright, http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0039 seconds