This thesis consists of three main objectives: fundamental and literature review of EV batteries, experimental development, and validation of two liquid cooling battery modules, thermal modeling and comparison of the inter-cell cooling battery module. / The traditional vehicles with internal combustion engine have resulted in severe environmental pollution, which motivates the development of electric vehicles and hybrid electric vehicles. Due to a low energy density and long refueling time of the battery pack, it is still hard for electric vehicles and hybrid electric vehicles to be widely accepted by the consumers. As the batteries with a better ultra-fast charging capability are massively produced, the range anxiety issue is somewhat alleviated.
During a charging with large current magnitude, the battery generally has a great amount of heat generation and evident temperature rise. Therefore, a thermal management system is necessary to effectively dissipate the battery loss and minimize the degradation mechanisms caused by extreme temperature. The motivation of this thesis is to study the discipline of the battery thermal management system as an application for electric vehicles. The design methodologies are presented in both experiment test and numerical simulation.
For the comparative study between active liquid cooling methods for a lithium-ion battery module using experimental techniques, two battery modules with three Kokam Nickel Manganese Cobalt battery cells connected in parallel are developed. One has liquid coolant flowing along the edge of the model, and another with liquid coolant flowing between the cells. Several characterization tests, including thermal resistance tests, fast charging tests up to 5C, and drive cycle tests are designed and performed on the battery module. The inter-cell cooling module has a lower peak temperature rise and faster thermal response compared to the edge cooling module, i.e., 4.1⁰C peak temperature rise under 5C charging for inter-cell cooling method and 14.2⁰C for edge cooling method.
The thermal models built in ANSYS represent the numerical simulation of the inter-cell cooling module as a comparison with the experiment. A cell loss model is developed to calculate the battery heat generation rate under ultra-fast charging tests and a road trip test, which are further adopted as the inputs to the thermal models. The simulation of the 5C ultra-fast charging test gives the peak temperature rise just 0.47⁰C lower than the experimental measurement, it indicates that the FEA thermal models can provide an accurate temperature prediction of the battery module. / Thesis / Master of Applied Science (MASc) / With a demanding market of electric vehicles, battery technologies have grown rapidly in recent years. Among all the battery research topics, the development of ultra-fast charging, that can fully charge the battery pack within 15 minutes, is the most promising direction to address the range anxiety and improve the social acceptance of electric vehicles. Nevertheless, the application of ultra-fast charging has many challenges. In particular, an efficient thermal management system is significant to guarantee the safety and prolong the service life of the battery pack. This thesis contributes to study the fundamentals of the battery field, and design liquid cooling systems to observe the thermal behavior of a battery prototype module under fast charging and general use. FEA thermal modeling of the battery module is developed to provide a guide for further test validation.
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/27017 |
| Date | January 2021 |
| Creators | Zhao, Ziyu |
| Contributors | Emadi, Ali, Mechanical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0021 seconds