<p> The foaming process has received increased attention by the rotational molding industry
in recent years. The use of metallocene catalyzed polyethylenes for producing a cellular structure is a new development in rotational molding. The objective of this work was to investigate the effects of different chemical blowing agents, resin properties and processing conditions on the structure of foamed metallocene polyethylene and obtain a fundamental understanding of the parameters governing the foam structure and part properties.</p> <p> An experimental study was conducted to produce metallocene polyethylene foams in dry-blending-based rotational foam molding. The physical and cell structure properties of the final foamed parts were examined. The critical processing parameters that optimize the foam structure have been identified through adjustments to the molding conditions.</p> <p> The foaming performance of exothermic and endothermic chemical blowing agents were examined and it was revealed that selecting an appropriate chemical blowing agent was crucial as the foam structure depends significantly on the properties of the blowing agent. Exothermic blowing agents resulted in greater foam density reduction compared to endothermic blowing agents.</p> <p> The effect of rheological properties on the foaming process and foam properties was also examined. Rotomolding experiments were performed in monolayer and skin-foam moldings. Observations indicated that the final foam properties were profoundly
influenced by the rheological properties of the polymer materials. There was a good correlation between the foam properties produced in both monolayer and two layer moldings. It was discovered that polymer materials with higher extensional viscosity could provide a promising foaming performance at different processing conditions.</p> <p> The effect of the surface tension of the polymer materials was investigated. It was found that type of reaction of the blowing agent (exothermic/endothermic) and composition of gas generated determine whether the surface tension of the resin contributes to the trend of changes in foam properties.</p> / Thesis / Master of Applied Science (MASc)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/22483 |
| Date | 08 1900 |
| Creators | Emami, Maryam |
| Contributors | Vlachopoulos, John, Chemical Engineering |
| Source Sets | McMaster University |
| Language | en_US |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.002 seconds