Return to search

Fluidized bed gasification of some western Canadian coals

Three different Western Canadian coals were gasified with air and steam in a fluidized bed of 0.73 mm Ottawa sand and coal, at atmospheric pressure, and temperatures of 1023 - 1175 K to produce a low Btu gas. The coals tested were of two types: one non-caking and two caking coals. The results were compared with those previously obtained for the same three coals when gasified in essentially the same equipment, but operated as a spouted bed.
The effects of temperature, coal feed rate, air to coal ratio, steam to coal ratio, coal quality, coal particle size, and bed depth on the gas composition, gas calorific value and the operating stability of the gasifier, were established by running gasification tests over a wide range of operating conditions.
Typical calorific value of the gas obtained for all three coals was in the range of 2.0 - 2.6 MJ/m³, which is lower than reported for the spouted bed and commercially available fluidized bed gasifiers. Analysis of the results suggested that in the present low temperature gasifier, the combustion and pyrolysis reactions predominate over the gasification reactions.
The ability to treat caking coals in fluidized bed and spouted bed reactors is discussed. It is concluded that the dispersion of coal in a bed of inert silica and ash, rather than hydrodynamic characteristics is the key-factor in their success in handling caking coals. / Applied Science, Faculty of / Chemical and Biological Engineering, Department of / Unknown

Identiferoai:union.ndltd.org:UBC/oai:circle.library.ubc.ca:2429/21758
Date January 1979
CreatorsGutierrez Despouy, Luis Alberto
Source SetsUniversity of British Columbia
LanguageEnglish
Detected LanguageEnglish
TypeText, Thesis/Dissertation
RightsFor non-commercial purposes only, such as research, private study and education. Additional conditions apply, see Terms of Use https://open.library.ubc.ca/terms_of_use.

Page generated in 0.0018 seconds