Return to search

Evaluation of Mechanical Properties of Provisional Fixed Partial Denture PMMA Material Containing Alumina Nanofibers

Indiana University-Purdue University Indianapolis (IUPUI) / Provisional restorative treatment is an essential part of fixed prosthodontics. Incorporation of adequately constructed provisional restorations will enhance the success rate of definitive restorations. Repairing or replacing failed provisional restorations is a concern for both clinicians and patients.
The objective of this investigation was to study the effects of alumina nanofibers reinforcement on the mechanical properties of commercially available provisional fixed partial denture PMMA material. The hypothesis was that the addition of alumina nanofibers to commercially available PMMA resin will significantly increase its flexural strength, fracture toughness, and microhardness. Alumina nanofibers at 0.0 wt %, 0.5 wt %, 1.0 wt %, and 2.5 wt % were added to commercially available provisional fixed partial material (Jet Tooth Shade). A quaternary ammonium acetate dispersant (CC-59, Goldschmidt, Janesville, WI) was added to the acrylic monomer at 0.0 wt %, 1.0 wt %, 2.0 wt % and 5.0 wt % of the nanofiber weight (12 test groups, 1 control). Samples from each group were evaluated for flexural strength, flexural modulus, fracture toughness, and microhardness. The samples were tested after storing in distilled water for 24 hours and 7 days at 37ºC. Two-way analysis of variance (ANOVA) was used to test the effects of storage time and combinations of alumina nanofiber level and quaternary ammonium acetate dispersant level on the flexural strength, fracture toughness, and microhardness of the provisional PMMA resin. Pair-wise comparisons between groups were performed using Tukey’s multiple comparisons procedure to control the overall significance level at 5 percent. Three fracture toughness samples/group were randomly selected for Energy Dispersive Spectrometry (EDS) to qualitatively evaluate the dispersion of the fibers.
The data obtained from this study showed that control sample values were in the acceptance range compared with previous research. The experimental samples did not reinforce the provisional resin in the flexural strength, modulus, fracture toughness, or microhardness. There are several factors may attribute to these results, such as poor bonding at the filler/matrix interface. The more homogeneous the mixture of PMMA and fiber, the stronger the acrylic resin. In fact, the presence of poorly bonded fibers, to which little load is transferred, can be almost equivalent to voids. In addition, as seen with EDS images, alumina nanofibers had a tendency to agglomerate. The use of a magnetic stirrer was not effective in physically separating nanofibers agglomerates. Direct dispersion of alumina nanofibers in methyl methacrylate monomer and quaternary ammonium acetate dispersant was not effective in separating the nanofibers into nano-scaled single crystals. The presence of fiber agglomerates acts as a structural defect that detrimentally affects the mechanical properties. Further studies are needed to evaluate the effectiveness of fibers, dispersion techniques, and coupling agents to enhance the mechanical properties of the provisional PMMA resin.

Identiferoai:union.ndltd.org:IUPUI/oai:scholarworks.iupui.edu:1805/2804
Date January 2012
CreatorsHajjaj, Maher Saeed, 1980-
ContributorsChu, Tien-Min Gabriel, Brown, David T., Platt, Jeffrey A., 1958-, Paez de Mendoza, Carmen Y., Levon, John A.
Source SetsIndiana University-Purdue University Indianapolis
Languageen_US
Detected LanguageEnglish
TypeThesis

Page generated in 0.0026 seconds