The present paper is concerned with the preparation of a filled elastomer by means the non-conventional bottom-up approach to polymer composites, alternatively with the conventional mechanical compounding of preformed filler particles with rubber. EPDM rubber was modified with in situ generated silica particles prepared by means of a sol-gel process adopting a solution process. The used synthetic procedure permitted the preparation of highly filled rubbers (up to 40 wt% of silica) with silica particle dimensions ranging from 0.2 to 2 μm. Equilibrium swelling and extraction tests indicated a hindering effect of the presence of in situ generated silica on the vulcanization process which reduced the cross-linking degree of the rubber matrix. Both tensile tests and dynamic-mechanical analysis showed a significant improvement in the mechanical properties due to the presence of the reinforcing filler, with an enhancement more significant than that expected from a simple hydrodynamic reinforcing mechanism.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:ufs/oai:etd.uovs.ac.za:etd-10302014-131003 |
| Date | 30 October 2014 |
| Creators | Mokhothu, Thabang Hendrica |
| Contributors | PROF M. MESSORI, PROF A.S. LUYT |
| Publisher | University of the Free State |
| Source Sets | South African National ETD Portal |
| Language | en-uk |
| Detected Language | English |
| Type | text |
| Format | application/pdf |
| Source | http://etd.uovs.ac.za//theses/available/etd-10302014-131003/restricted/ |
| Rights | unrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University Free State or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report. |
Page generated in 0.0098 seconds