Power consumption requires critical consideration during system design for portable wireless communication devices as it has a direct influence on the battery weight and volume required for operation. Wideband Code Division Multiple Access (W-CDMA) techniques are favoured for use in future generation mobile communication systems. This thesis investigates novel low power techniques for use in system blocks within a W-CDMA adaptive linear minimum mean squared error (LMMSE) receiver architecture. Two low power techniques are presented for reducing power dissipation in the LMS adaptive filter, this being the main power consuming block within this receiver. These low power techniques are namely the decorrelating transform, this is a differential coefficient technique, and the variable length update algorithm which is a dynamic tap-length optimisation technique. The decorrelating transform is based on the principle of reducing the wordlength of filter coefficients by using the computed difference between adjacent coefficients in calculation of the filter output. The effect of reducing the wordlength of filter coefficients being presented to multipliers in the filter is a reduction in switching activity within the multiplier thus reducing power consumed. In the case of the LMS adaptive filter, with coefficients being continuously updated, the decorrelating transform is applied to these calculated coefficients with minimal hardware or computational overhead. The correlation between filter coefficients is exploited to achieve a wordlength reduction from 16 bits down to 10 bits in the FIR filter block. The variable length update algorithm is based on the principle of optimising the number of operational filter taps in the LMS adaptive filter according to operating conditions. The number of taps in operation can be increased or decreased dynamically according to the mean squared error at the output of the filter. This algorithm is used to exploit the fact that when the SNR in the channel is low the minimum mean squared error of the short equaliser is almost the same as that of the longer equaliser. Therefore, minimising the length of the equaliser will not result in poorer MSE performance and there is no disadvantage in having fewer taps in operation. If fewer taps are in operation then switching will not only be reduced in the arithmetic blocks but also in the memory blocks required by the LMS algorithm and FIR filter process. This reduces the power consumed by both these computation intensive functional blocks. Power results are obtained for equaliser lengths from 73 to 16 taps and for operation with varying input SNR. This thesis then proposes that the variable length LMS adaptive filter is applied in the adaptive LMMSE receiver to create a low power implementation. Power consumption in the receiver is reduced by the dynamic optimisation of the LMS receiver coefficient calculation. A considerable power saving is seen to be achieved when moving from a fixed length LMS implementation to the variable length design. All design architectures are coded in Verilog hardware description language at register transfer level (RTL). Once functional specification of the design is verified, synthesis is carried out using either Synopsys DesignCompiler or Cadence BuildGates to create a gate level netlist. Power consumption results are determined at the gate level and estimated using the Synopsys DesignPower tool.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:562082 |
| Date | January 2007 |
| Creators | Tennant, Mark P. |
| Contributors | Thompson, John |
| Publisher | University of Edinburgh |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://hdl.handle.net/1842/2565 |
Page generated in 0.0042 seconds