In aviation industry, one of the most important aspects is weight savings. This since with a lowered weight, the performance of the aircraft can be increased together with increased fuel savings and thus lowered running costs. One way of saving weight is to reduce energy consumption, since with lowered energy consumption, lowered mass of fuel is required etc. Most aircraft are today maneuvered with hydraulic systems due to its robustness and power density. It is the primary source of power for primary and secondary flight controls. The control of a conventional system which is using proportional valves is done by altering flow by restricting it to the extent where the desired output is achieved, which implies heat losses since the full performance of its supply is wasted through the valve. In previous research, more energy efficient hydraulic systems called digital hydraulics has been investigated. In difference with conventional hydraulics, digital hydraulics uses low cost, high frequency on/off valves, which either are fully opened, or fully closed, instead of proportional valves to achieve the desired output. With this comes the benefit of no energy losses due to leakage and restriction control. The downsides with digital hydraulics is the controlabillity. One way of controlling it is by using several pressure sources which outputs different pressure levels. By using the on/off valves in different combinations, different outputs can be achieved in a discrete manner. In this thesis, the aim was to remove the impact of the discrete force steps which are present in digital hydraulics by creating concepts with hybrid solutions containing both digital hydraulics and restrictive control. Three concepts were developed and investigated using simulation. The energy consumption and performance was analysed and compared with a reference model, the concepts redundancy compared to conventional systems was discussed and finally the concepts were tested with an aircraft simulation model. The concepts were found to reduce the energy consumption with different magnitude depending on the load cycle. The performance was found to be almost as good as the reference model. The redundancy compared with conventional systems should be possible to maintain with slight modifications, but further investigation is needed. It was found that one of the most important aspects regarding energy consumption is which combination of supply pressures is used to supply the system since it influences leakage and flow due to compression.
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:liu-165262 |
| Date | January 2019 |
| Creators | Larsson, Felix, Johansson, Christian |
| Publisher | Linköpings universitet, Fluida och mekatroniska system, Linköpings universitet, Fluida och mekatroniska system |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Student thesis, info:eu-repo/semantics/bachelorThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
Page generated in 0.0031 seconds