The high temperature microstructure of the solid phases within the electric arc furnace (EAF) slag has a large effect on the process features such as foamability of the slag, chromium recovery, consumption of the ferroalloys and the wear rate of the refractory. The knowledge of the microstructural and compositional evolution of the slag phases during the EAF process stages is necessary for a good slag praxis. In supplement 1, an investigation of the typical characteristics of EAF slags in the production of the AISI 304L stainless steel was carried out. In addition, compositional and microstructural evolution of the slag during the different EAF process stages was also investigated. Computational thermodynamics was also used as a tool to predict the equilibrium phases in the top slag as well as the amount of these phases at the process temperatures. Furthermore, the influence of different parameters (MgO wt%, Cr2O3 wt%, temperature and the top slag basicity) on the amount of the spinel phase in the slag was studied. In supplement 2, a novel study to characterize the electric arc furnace (EAF) slags in the production of duplex stainless steel at the process temperatures was performed. The investigation was focused on determining the microstructural and compositional evolution of the EAF slag during and at the end of the refining period. Slag samples were collected from 14 heats of AISI 304L steel (2 slag samples per heat) and 7 heats of duplex steel (3 slags sample per heat). Simultaneously with each slag sampling, the temperature of the slag was measured. The selected slag samples were studied both using SEM-EDS and LOM. In some cases (supplement 2), X-ray diffraction (XRD) analyses were also performed on fine-powdered samples to confirm the existence of the observed phases. It was observed that at the process temperature and at all process stages, the stainless steel EAF slag consists mainly of liquid oxides, magnesiochromite spinel particles and metallic droplets. Under normal operation and at the final stages of the EAF, 304L steelmaking slag contains 2-6 wt% magnesiochromite spinel crystals. It was also found that, within the compositional range of the slag samples, the only critical parameter affecting the amount of solid spinel particles in the slag is the chromium oxide content. Petrographical investigation of the EAF duplex stainless steelmaking showed that, before FeSi-addition, the slag samples contain large amounts of undissolved particles and the apparent viscosity of the slag is higher, relative to the subsequent stages. In this stage, the slag also includes solid stoichiometric calcium chromite. It was also found that, after FeSi-injection into the EAF and during the refining period, the composition and the basicity of the slag in the EAF duplex steelmaking and EAF stainless steelmaking are fairly similar. This indicates that, during the refining period, the basic condition for the utilization of an EAF foaming-slag praxis, in both austenitic and duplex stainless steel cases, is the same. Depending on the slag basicity, the slag may contain perovskite and/or dicalcium silicate too. More specifically, the duplex stainless steel slag samples with a higher basicity than 1.55 found to contain perovskite crystals. / QC 20110413
| Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:kth-12064 |
| Date | January 2010 |
| Creators | Mostafaee, Saman |
| Publisher | KTH, Materialvetenskap, Stockholm : KTH Royal Institute of Technology |
| Source Sets | DiVA Archive at Upsalla University |
| Language | English |
| Detected Language | English |
| Type | Licentiate thesis, comprehensive summary, info:eu-repo/semantics/masterThesis, text |
| Format | application/pdf |
| Rights | info:eu-repo/semantics/openAccess |
Page generated in 0.0028 seconds