H13 tool steel is widely used in the mold and die industry. Due to tighter geometric tolerances and higher quality expectations, the use of hard machining has increased over the years. Hard machining refers to the machining of materials in their hardened state. The challenges with hard machining are rapid tool wear and maintaining a high surface integrity of the machined surface. Surface integrity is measured in terms of surface roughness, residual stresses, presence of surface and subsurface cracks, and the quality of the developed microstructure. In order to minimize wear and improve product quality, researchers are working on the development of different tool coatings. Some of the recent tool coatings function by adapting to their environment using heat to form thin layers of oxides, referred to as ―tribo-films‖, on the surface of the tool. If engineered properly, these tribofilms can prolong tool life and improve the surface integrity of a hard machined surface. A titanium based nano multi-layered coating (TiAlCrSiYN/TiAlCrN) has been developed by researchers at the MMRI. The tribological performance of two different coatings TiAlCrSiYN/TiAlCrN and TiAlCrN were tested in a hard machining metal cutting process. The impact of these coatings on tool wear, Cutting process (Chips) and Surface Integrity (Quality of machined surface) was assessed. This research involves characterizing the coating to understand how the formation of different oxide films (tribofilms) effect tool wear and surface integrity. The generation of these tribofilms is sensitive to coating composition and cutting condition (temperature/pressure). Next, an in-depth characterization of the chips produced during machining was carried out as part of studying the effect of different tribological conditions between the tool and workpiece. The chip's hardness, oxidation, chip formation mechanism and topography as the chip slid against the cutting tool surface was studied. Also, the Surface integrity of the machined part was investigated, considering its microstructure, residual stresses and surface roughness. Lastly, tests were performed in an attempt to accelerate the generation of beneficial tribofilms. Results indicate significant improvement in wear life and surface integrity of the machined surface due to the generation of tribo-films in this machining application. / Thesis / Master of Applied Science (MASc)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/18038 |
| Date | 11 1900 |
| Creators | Arif, Taib |
| Contributors | Veldhuis, Stephen, Mechanical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0021 seconds