In the South African gold mining industry, mining is being conducted at depths of over 3 000 m below the surface. Severe fracturing and deformation of the rock occurs making it unlikely that stress analysis which treats the rock as a homogeneous elastic material will yield useful results about the behaviour around the excavation. The excavation, or stope, considered in this study is tabular. The stope occurs in stratified rock with bedding planes at approximately 1 m intervals. The height of the stope is about 1 m to 1.5 m and the length increases to over 100 m as mining progresses. Shear fractures initiate ahead of the advancing stope, which together with the bedding planes separate the rock into distinct blocks of relatively intact material. The stratified nature of the material in the hangingwall (or roof) of the excavation, and the lack of cohesion in the bedding planes, suggests that separation occurs along the bedding planes, with each layer supporting its own weight. The lowest of these layers is referred to as the "hangingwall beam". Stope closure occurs at a distance of around 30 to 40 m behind the stope face. This study focuses on the mechanics of the hangingwall beam with particular emphasis on the conditions for stable closure. In order to do this the stope is first analysed using a finite element model which treats the rock as a homogeneous elastic medium. By treating the hangingwall beam as a separate layer, 1 m thick, its behaviour is compared to that observed in practice. We find that the hangingwall beam does separate from the overlying rock, but that the axial stresses in the beam are tensile, thus contradicting the observed behaviour. In practice, compressive stresses exist in the hangingwall and footwall. It has been suggested that slip along the shear fractures generates the compressive stresses. In constructing a mathematical model of the hangingwall beam we consider the beam to be made up of blocks 1 m deep and 1 m long. The blocks are treated as a homogeneous elastic material. The behaviour of such a beam is different from that of a fully homogeneous beam, because of the possibility of the formation of hinges. By considering a range of simplified models of a beam composed of blocks, various questions regarding its stability can be addressed. These models consider beams of fixed span in which the weight is increased from zero to the full value. The largest unsupported halfspan which can be stably equilibrated is of the order of 31 m. The maximum stable deflection is 0. 4 m, and therefore additional support is required to allow closure to occur statically. The nature of a single supporting spring that will let down the beam in a limiting, stable manner is identified. Once closure has taken place, the hangingwall beam is stable. In order to obtain a realistic picture of the steady state configuration of the hangingwall beam, an analysis is performed which simulates the advancing stope face. The results show that the distance between the face and the point of closure is around 34 m which is in accord with the behaviour observed in practice. The results have shown that the model which treats the hangingwall as a beam composed of blocks provides useful information about the mechanics of the hangingwall.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:uct/oai:localhost:11427/18466 |
| Date | January 1989 |
| Creators | De Villiers, N A |
| Contributors | Martin, J B, Bird, Wyndham Wadham |
| Publisher | University of Cape Town, Faculty of Engineering and the Built Environment, Department of Civil Engineering |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Master Thesis, Masters, MSc (Eng) |
| Format | application/pdf |
Page generated in 0.0022 seconds