The aim of this study is to investigate means of efficiently assessing the effects of distributed structural modification on the dynamic properties of a complex structure. The helicopter structure is normally designed to avoid resonance at the main rotor rotational frequency. However, very often military helicopters have to be modified (such as to carry a different weapon system or an additional fuel tank) to fulfill operational requirements. Any modification to a helicopter structure has the potential of changing its resonance frequencies and mode shapes. The dynamic properties of the modified structure can be determined by experimental testing or numerical simulation, both of which are complex, expensive and time-consuming. Assuming that the original dynamic characteristics are already established and that the modification is a relatively simple attachment such as beam or plate modification, the modified dynamic properties may be determined numerically without solving the equations of motion of the full-modified structure. The frequency response functions (FRFs) of the modified structure can be computed by coupling the original FRFs and a delta dynamic stiffness matrix for the modification introduced. The validity of this approach is investigated by applying it to several cases, 1) 1D structure with structural modification but no change in the number of degree of freedom (DOFs). A simply supported beam with double thickness in the middle section is treated as an example for this case; 2) 1D structure with additional DOFs. A cantilever beam to which a smaller beam is attached is treated as an example for this case, 3) 2D structure with a reduction in DOFs. A four-edge-clamped plate with a cut-out in the centre is treated as an example for this case; and 4) 3D structure with additional DOFs. A box frame with a plate attached to it as structural modification with additional DOFs and combination of different structures. The original FRFs were obtained numerically and experimentally except for the first case. The delta dynamic stiffness matrix was determined numerically by modelling the part of the modified structure including the modifying structure and part of the original structure at the same location. The FRFs of the modified structure were then computed. Good agreement is obtained by comparing the results to the FRFs of the modified structure determined experimentally as well as by numerical modelling of the complete modified structure.
| Identifer | oai:union.ndltd.org:ADTP/258772 |
| Date | January 2009 |
| Creators | Hang, Huajiang, Engineering & Information Technology, Australian Defence Force Academy, UNSW |
| Publisher | Awarded by:University of New South Wales - Australian Defence Force Academy. Engineering & Information Technology |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://unsworks.unsw.edu.au/copyright |
Page generated in 0.0021 seconds