Lowering the operating temperature of the high-temperature, solid oxide fuel cell (SOFC) improves both the thermodynamic efficiency and the lifetime of this energy efficient technology. Unfortunately the rate of oxygen-ion transport through the solid electrolyte is temperature dependent, and materials previously employed as electrolytes in the high-temperature SOFC perform poorly at intermediate temperatures. Therefore new oxygen-ion conductors with enhanced ionic conductivity at intermediate temperatures are required. The bulk of the existing literature on high-temperature SOFCs has focussed on zirconia-based binary systems as electrolytes, due to their high ionic conductivity and negligible electronic conductivity. Only select compositions within the zirconia-scandia system have demonstrated acceptable ionic conductivity levels at intermediate temperatures; however unstable phase assemblage and the high economic cost of scandia are clear disadvantages. Ceria-based binary systems have demonstrated improved oxygen-ion conductivity at intermediate temperature compared to many zirconia systems, however significant levels of n-type electronic conductivity are observed at low oxygen partial pressures. Consequently it was thought unlikely that significant increases in ionic conductivity would be found in existing zirconia- and ceria-based binary systems, therefore another approach was required in an attempt to improve the performance of these established fluorite systems. The fluorite systems Zr0.75Ce0.08M0.17O1.92 (M = Nd, Sm, Gd, Dy, Ho, Y, Er, Yb, Sc) were prepared and investigated as possible, intermediate-temperature SOFC electrolytes in an attempt to combine the higher conductivity found in the ceria systems with the low electronic conductivity observed in the zirconia systems. Also it was anticipated that systems containing dopants not previously observed to confer high ionic conductivity in either zirconia- and ceria-based binary systems, might exhibit enhanced ionic conductivity with expansion of the zirconia lattice resulting from the addition of ceria. All the as-fired Zr0.75Ce0.08M0.17O1.92 compositions possessed the face-centred cubic structure and lattice parameter measurements revealed the anticipated unit cell enlargement as the size of the dopant cation increased. No unusual microstructural parameters were identified that could be expected to interfere with the ionic transport properties in the as-fired compositions. The electrical conductivity was found to be influenced by the dopant-ion radius, the presence of ceria, low oxygen partial pressures and, in some compositions, the formation of poorly conducting, ordered-pyrochlore microdomains dispersed amongst the cubic defect-fluorite matrix. In a second approach to the formulation of new oxygen-ion conductors suitable for the intermediate-temperature SOFC, compounds possessing structures other than the fluorite structure were considered. An examination of the literature for oxides having the pyrochlore, scheelite and perovskite structures showed that the Sr+2- and Mg+2-doped LaGaO3 perovskites (LSGM) possessed ionic conductivity equal to the highest conducting, zirconia and ceria binary compounds. Therefore the perovskite systems La0.9Sr0.1Ga(0.8-x)InxMg0.2O2.85 (X = 0, 0.05, 0.1, 0.2, 0.4, 0.6, 0.8) (I-LSGM) were prepared and examined, the objective being to favourably influence structural parameters believed responsible for optimal ionic conductivity, namely the unit cell symmetry and volume. It was found that In+3 systematically substituted for Ga+3 on to the B-site of LSGM at least up to the X = 0.4 composition. While In+3 was found to replace the Ga+3 as expected, Mg+2, which occupies the same crystallographic site, was also replaced by In+3. Up to the X = 0.2 composition, at least two trace level secondary phases were observed to form along with the bulk I-LSGM phase. For I-LSGM compositions with X > 0.2, significantly larger concentrations of the secondary phases were identified. Evidence of a strontium-rich, high-temperature liquid phase was observed also near the grain boundaries on as-sintered and thermally etched surfaces in LSGM and I-LSGM compositions. It is believed that the observed, high sintered density in the complex, doped-LaGaO3 systems is due to the formation of this high-temperature liquid phase. Increasing levels of diffuse scatter and superstructure formation were observed in electron diffraction patterns in the I-LSGM bulk phase (up to X = 0.2), indicating a possible decrease in vacancy concentration and reduced, localised unit cell symmetry. The electrical conductivity in the I-LSGM compositions was believed to be influenced by the distortion of the oxygen-ion conduction path, a reduction in vacancy concentration, formation of stronger dopant-vacancy associates at low temperature and the presence of ordered structures. In addition, phase instability, in the form of subtle ordering in specific crystalline planes, was observed to influence the electrical conductivity as a function of time at intermediate temperatures.
| Identifer | oai:union.ndltd.org:ADTP/216670 |
| Date | January 2002 |
| Creators | Kimpton, Justin Andrew, jkimpton@physics.unimelb.edu.au |
| Publisher | Swinburne University of Technology. |
| Source Sets | Australiasian Digital Theses Program |
| Language | English |
| Detected Language | English |
| Rights | http://www.swin.edu.au/), Copyright Justin Andrew Kimpton |
Page generated in 0.0012 seconds