The calculation of the loadbearing capacity of hollow section joints using the design formulas according to EN 1993-1-8 assumes full-strength welded connections if the non-linear stress distribution over the circumference is not covered by calculation. Sufficient ductility in the connections ensures a plastic redistribution capacity within each joint. In the case of hollow section structures made of high-strength steels, it becomes more difficult to meet the requirement for full-strength welds as the yield strength of the base material increases.
This article begins with a summary of the current rules for the design and execution of welded hollow section joints. The softening behaviour of high-strength steels and the loadbearing capacity of welded connections with local softening in the HAZ are then discussed. That is followed by the presentation of the results from the AiF-FOSTA research project P1020 regarding the influence of manufacturing parameters on the properties of welded connections and the HAZ. The experimental test programme for single-sided welded T-connections and the parameter studies within the research project P1453 are also described. Finally, a design approach is presented to account for HAZ failure and hybrid failure modes of hollow section connections.
| Identifer | oai:union.ndltd.org:DRESDEN/oai:qucosa:de:qucosa:90405 |
| Date | 08 April 2024 |
| Creators | Stroetmann, Richard, Kästner, Thoralf, Rust, Brian, Schmidt, Jan |
| Publisher | Ernst & Sohn |
| Source Sets | Hochschulschriftenserver (HSSS) der SLUB Dresden |
| Language | English |
| Detected Language | English |
| Type | info:eu-repo/semantics/publishedVersion, doc-type:article, info:eu-repo/semantics/article, doc-type:Text |
| Rights | info:eu-repo/semantics/openAccess |
| Relation | 1867-0539, 10.1002/stco.202100036 |
Page generated in 0.0019 seconds