One of the most significant challenges in the composite development field is to find a low-cost manufacturing route capable of producing large volumes of material. This thesis develops and characterises a potential avenue for addressing this, an induction furnace-based process. This process produced a composite of A357 matrix and 10% wt Dramix 3D 80/30 SL steel fibres. The method was evaluated by microstructural analysis and optimum casting parameters were approximated. The fibres were introduced to liquid A357 at 700°C and the composite was brought to a measured temperature of 650°C over not more than 120 seconds before being removed from the furnace and cooled. 10% wt was the ideal reinforcement ratio for this process. Characterising the tensile and compressive strength of the composite material, it reached a peak stress 130% higher than A357 produced under the same conditions, though the peak stresses were still 20% of the literature values for T6 tempered A357. This suggests the need for development of a temper which does not degrade the properties of the composite. 3-point bending tests and some tensile specimens also showed post-failure strength. Under dynamic loading, the composite showed a peak stress in excess of 100 MPa without reaching maximum compression under SHPB loading, and comparable performance to SiC-reinforced MMCs under ballistic testing. The linear decrease in work-hardening with increasing distance from the impact site shows shock and pressure-pulse dissipation properties, attributed to the difference in acoustic impedance between the matrix and the reinforcement.
| Identifer | oai:union.ndltd.org:bl.uk/oai:ethos.bl.uk:765037 |
| Date | January 2018 |
| Creators | Davenport, Rebecca A. |
| Contributors | Nadendla, H. ; Eskin, D. |
| Publisher | Brunel University |
| Source Sets | Ethos UK |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Source | http://bura.brunel.ac.uk/handle/2438/17033 |
Page generated in 0.0019 seconds