Return to search

. Drilling Parameters and Their Effect on Chip Clogging and Surface Roughness

<p>In the woodworking industry, drilling (boring) is one of the most extensively used processes. Due to the traditional nature of the woodworking industry, not much data on machining has been recorded, only a fraction of this on drilling. This lack of information hinders the understanding and thus improvement in the process of drilling. The objective of this research is to provide a pilot study on chip clogging and the surface finish generated while drilling wood and also to examine the surface breakout at the point of drill entry and exit while drilling. This will help the industry by giving an insight into the drilling of wood for furthering research in focused areas. Experiments on chip clogging were carried out with two sizes of standard twist drills and the effect of feed (in/rev), spindle speed (rpm), passage of air jet, pecking cycle and rotational tool were studied on chip clogging. For the study of surface finish, a full factorial experimental design was implemented to evaluate the effect of factor level combinations of four wood types, four drill types, grain directions (along and across the grain), spindle speed (rpm) and feed (in/rev) and their interactions with respect to the surface quality of the machined workpiece. These 128 factor level combinations were replicated three times for a total of 384 experiments. The data obtained was statistically tested by using the analysis of variance techniques to prove the level of significance for each factor and interaction with respect to the surface finish. Work on chip clogging shows promise and needs further investigation for the benefit of the industry. Results on the surface finish study show trends in the behavior of parameters and future work should include developing mathematical models for accurately predicting responses with respect to the input parameters.<P>

Identiferoai:union.ndltd.org:NCSU/oai:NCSU:etd-19991220-172709
Date03 January 2000
CreatorsJoshi, Sandesh Surendra
ContributorsDr. James B. Taylor, Dr. Denis Cormier, Dr. Thomas Honeycutt
PublisherNCSU
Source SetsNorth Carolina State University
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://www.lib.ncsu.edu/theses/available/etd-19991220-172709
Rightsunrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to NC State University or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report.

Page generated in 0.0151 seconds