Return to search

The influence of the microstructural shape on the mechanical behaviour of interpenetrating phase composites

The microstructure-property relationship for interpenetrating phase composites (IPCs) is currently poorly understood. In an attempt to improve this understanding this study focused on one particular part of this relationship: the effect of phase shape on the elastic and plastic behaviour. A review of previous research showed that investigations had linked phase shape to the elastic and plastic behaviour of various inclusion reinforced composites, but that no similar work had been completed for IPCs. <p> To study the complex response of the IPC microstructure under load, a numerical modelling analysis using the finite element method (FEM) was undertaken. Two three-dimensional models of IPCs were created, the first consisting of an interconnected spherical phase with the interstitial space forming the other interconnected phase, and the second replacing the spherical phase with an interconnected cylindrical phase. With the simulation of a uniaxial tension test under elastic and plastic conditions, these two models exhibited different responses based on the shape of the phases. <p> Results from an analysis of the macroscopic behaviour identified that the cylindrical model produced greater effective properties than the spherical model at the same volume fraction. The influence of phase shape was connected to the increased contiguity of the superior phase within the IPC for the cylindrical model, which allowed similar levels of long-range continuity with smaller amounts of the superior phase (compared to the spherical model). <p> An examination of microstructural stress distributions showed that preferential stress transfer occurred along paths of low compliance. This provided an explanation of how the improved contiguity of the stiffer (or stronger) phase could enhance the macroscopic effective properties of an IPC. Contiguity of the stronger phase was particularly important for plastic behaviour, where early yielding of the weaker phase requires the stronger phase to carry nearly all the load within itself.

Identiferoai:union.ndltd.org:USASK/oai:usask.ca:etd-03232005-182730
Date24 March 2005
CreatorsDel Frari, Gregory Albert
ContributorsYannacopoulos, Spiro, Wegner, Leon D., Sparling, Bruce F., Peng, Jian, Boulfiza, Mohamed
PublisherUniversity of Saskatchewan
Source SetsUniversity of Saskatchewan Library
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://library.usask.ca/theses/available/etd-03232005-182730/
Rightsunrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report.

Page generated in 0.0022 seconds