The metal industry supplies its products in a great variety of shapes and conditions for use by the fabricator. One of the most important forms is sheet or strip which may be used as they are, or fabricated further by such processes as drawing and spinning. The manufacturing process for metal sheet is the subject of this work; the metal investigated was copper. The purpose of the study was to measure the mechanical properties of copper sheet produced by two different methods, and to compare the data in order to see if one method had any clear advantages over the other. The first method of sheet production, which we may call temper rolling, is the one that is used almost exclusively in industry. This is the method discussed immediately below. The other sheet production method, which may be called partial annealing, has been used only in isolated cases. This method is dealt with after a discussion of temper rolling.
| Identifer | oai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:QMM.115490 |
| Date | January 1964 |
| Creators | Fritz, Howard. M. |
| Contributors | Williams, W. (Supervisor) |
| Publisher | McGill University |
| Source Sets | Library and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada |
| Language | English |
| Detected Language | English |
| Type | Electronic Thesis or Dissertation |
| Format | application/pdf |
| Coverage | Master of Engineering. (Department of Engineering.) |
| Rights | All items in eScholarship@McGill are protected by copyright with all rights reserved unless otherwise indicated. |
| Relation | alephsysno: NNNNNNNNN, Theses scanned by McGill Library. |
Page generated in 0.0015 seconds