Nowadays, the need for three-dimensional miniaturized components is increasing in many areas, such as electronics, biomedics, aerospace and defence, etc. To support the demands, various micro-scale fabrication techniques have been further introduced and developed over the last decades, including micro-electric-mechanical technologies (MEMS and LIGA), laser ablation, and miniature machine tools (mMTs). Each of these techniques has its own benefits, however miniature machine tools are superior to any others in enabling three-dimensional complex geometry with high relative accuracy, and the capability of dealing with a wide range of mechanical materials. Thus, mMTs are emerging as a promising fabrication process. In this work, various researches have been carried out based on the mMTs. The thesis presents micro-machining, in particular, micro-milling force model and three relevant subsystems for miniature machine tools (mMTs), to enhance machining productivity/efficiency and dimensional accuracy of machined parts.
The comprehensive force model that predicts micro-endmilling dynamics has been developed. Unlike conventional macro-machining, the cutting mechanism in micro-machining is complex with high level of non-linearity due to the combined effects of edge radius, size, and minimum chip thickness effect, etc., resulting in no chip formation when the chip thickness is below the minimum chip forming thickness. Instead, part of the work material deforms plastically under the edge of a tool and the rest of the material recovers elastically. The developed force model for micro-endmilling is effective to understand the micro-machining process. As a result, the micro-endmilling force model is helpful to improve the quality of machined parts. In addition, three relevant subsystems which deliver maximum machining productivity and efficiency are also introduced. Firstly, ultrasonic atomization-based cutting fluid application system is introduced. During machining, cutting fluid is required at the cutting zone for cooling and lubricating the cutting tool against the workpiece. Improper cutting fluid application leads to significantly increased tool wear, and which results in overall poor machined parts quality. For the micro-machining, conventional cooling methods using high pressure cutting fluid is not viable due to the potential damage and deflection of weak micro-cutting tools. The new atomization-based cutting fluids application technique has been proven to be quite effective in machinability due to its high level of cooling and lubricating.
Secondly, an acoustic emission (AE)-based tool tip positioning method is introduced. Tool tip setting is one of the most important factors to be considered in the CNC machine tool. Since several tools with different geometries are employed during machining, overall dimensional accuracy of the machined parts are determined by accurate coordinates of each tool tip. In particular, tool setting is more important due to micro-scale involved in micro-machining. The newly developed system for tool tip positioning determines the accurate coordinates of the tool tip through simple and easy manipulation. At last, with the advance of the 3D micro-fabrication technologies, the machinable miniaturized components are getting complex in geometry, leading to increased demand on dimensional quality control. However, the system development for micro-scale parts is slow and difficult due to complicated detection devices, algorithm, and fabrication of a micro-probe. Consequently, the entire dimensional probing system tends to become bulky and expensive. A new AE-based probing system with a wire-based probe was developed to address this issue with reduced cost and size, and ease of application. / Graduate
| Identifer | oai:union.ndltd.org:uvic.ca/oai:dspace.library.uvic.ca:1828/3433 |
| Date | 29 July 2011 |
| Creators | Goo, Chan-Seo |
| Contributors | Jun, Martin Byung-Guk |
| Source Sets | University of Victoria |
| Language | English, English |
| Detected Language | English |
| Type | Thesis |
| Rights | Available to the World Wide Web |
Page generated in 0.0024 seconds